HOME DVD PLAYER | V10M10_IM_EN_08072006 |
|
|
GETTING STARTED |
|
Installing the Remote Control | Notes on Using the Remote Control |
Batteries | Please note that a remote control should be |
1. Open the battery compartment cover on | pointed directly at the remote control sensor |
the back of the remote control. | to get the better performance. |
2.Place two “AAA” batteries as shown on the picture below. Make sure that the polarity
3.Close the battery compartment.
Notes on Remote Control
1.Improper use of batteries may cause the battery leakage and corrosion. To operate the remote control correctly, follow the instructions below:
a.Do not insert the batteries in the wrong direction.
b.Do not attempt to recharge,
c.Do not leave the dead batteries in the remote control.
d.Do not use or mix the different types of batteries or old and new batteries together.
HOME DVD PLAYER | V10M10_IM_EN_08072006 |
GETTING STARTED
Notes on Remote Control – Continued
e.If you do not use the remote control for a long period of time, remove the installed batteries from the remote control to avoid possible damage from the battery corrosion. If battery leakage occurs, clean the battery compartment and then insert the new batteries. Please follow the general safety and handling instructions listed by the battery manufacturer. After cleaning, wash your hand.
2.Do not leave the remote control in an extremely hot or humid place.
3.Do not spill water or put any liquid on the remote control.
4.Do not expose the remote control sensor of the DVD player to a strong light source, such as direct sunlight.
5.The battery life is approximately one year under the normal working condition. However, it significantly depends on the battery type and its working condition. If the remote control doesn’t work or the signal gets weaker, replace the battery. The alkaline batteries are recommended for the longer battery life.
You can help to protect the environment!
Please do not throw the used batteries away and follow the local regulations for the proper disposal of the used batteries.
Brief Instructions on Installing the DVD Player
1.Locate the place where you want to install this unit.
2.Refer to the quick connection guides starting on the following page to connect this unit to other audio or display devices. While installing this unit to other devices, the power cord of all devices in the installation process should be properly disconnected for the safety purpose.
3.Connect the power cord of all devices again. Before connecting the power cords, please carefully follow the safety instructions in the section of the user safety guide.
4.After connecting the power cords, turn on this unit and all the attached devices.
5.Before operating this unit, set the system settings of this unit and all the attached devices based on your choice of the connection. To properly show the video and audio contents, this unit and all the attached devices must be set with the correct system settings accordingly based on your choice of the connection. For this unit, refer to the detailed system setup instructions in this user’s manual. For the attached devices, refer to the detailed system setup instructions in their user’s manuals respectively.
Special Notes
1.If this unit is not going to be used for a long period of time, please disconnect the power cord plug from the outlet.
2.This unit must be operated with the correct power supply corresponding to the marking label on the back of the unit.
3.This unit may not be compatible with some specially encrypted discs.
12 | www.jWIN.com | 13 | www.jWIN.com |