
Connecting Alarm Device - Appendix #5
Connecting Alarm Device - Appendix #5
Alarm controls are enabled through the Menu system on the DVR. Additional alarm devices can be connected to the system (Motion Sensors, Door/Window Sensors).
DVR
SENSOR
A motion detection or sensor unit can be used to send a signal to the DVR to begin camera viewing on the matching Video Channel (when enabled in the MENU/ALARM SET MODE)
•Example: A Window sensor unit has been installed on Alarm Block port #1. When this sensor is activated, ALL CAMERAS will become active (if enabled in the MENU on the DVR)
For the corresponding Menu Programming, refer to Page 26.
Installing a Sensor
1.Connect the GROUND Cable to the GND port on the Alarm Block on the DVR
2. Connect the SIGNAL Cable to a numbered port
2 1
41