SET UP FOR USE
TV SECTION
SELECTING THE LANGUAGE
TV
1Plug in the unit power cord
Plug the unit power cord into a standard
AC outlet.
NOTE:
• If any digits appear in the corner of the screen, hit [POWER] without unplugging the power cord.
Make sure ...
•Hit [POWER] to turn on the unit.
NOTE:
•This function effects only the language on the screen menu and not the audio source.
2 Select “LANGUAGE” | - TV SETUP - |
Hit [SETUP] on the remote control. | CHANNEL SET UP |
Press [K/L] to point to “LAN- | |
CAPTION [OFF] | |
| B LANGUAGE [ENGLISH] |
GUAGE”. |
|
3Select “ENGLISH”, “ESPAÑOL” or “FRANÇAIS”
Select “ENGLISH”, “ESPAÑOL”= Spanish or “FRANÇAIS”= French using [ENTER].
4Exit the Language mode
Hit [SETUP] to return to TV mode.
NOTE: If for some reason the menu is in Spanish or French, press [K/L] to point to “IDIOMA [ESPAÑOL]” or “LANGAGE [FRANÇAIS]”, then hit [ENTER], then hit [SETUP] on the remote con-
CHANNEL SET UP
TV
You can program the tuner to scan all the channels you receive in your area.
NOTE: Channel memory programming is NOT needed when connected to a cable box or satellite box. Just select the unit channel selector to the output channel of the cable box or satellite box (Ex CH3), then select the channel to be viewed on the Cable Box or Satellite Box.
Make sure ...
• Hit [POWER] to turn on the unit.
1 Select “CHANNEL SET UP” |
| |
Hit [SETUP] on the remote control. | - TV SETUP - | |
Press [K/L] to point to “CHAN- | B CHANNEL SET UP | |
NEL SET UP”. | ||
LANGUAGE [ENGLISH] | ||
CAPTION [OFF] | ||
Then hit [ENTER]. | ||
| ||
|
| |
2 Begin auto ch programming |
| |
Press [K/L] to point to “AUTO CH | – CHANNEL SET UP – | |
PROGRAMMING”. | ADD / DELETE CH (CATV) | |
Then hit [ENTER]. | B AUTO CH PROGRAMMING | |
The tuner scans and memorizes all |
| |
the active channels in your area. |
|
3After scanning
The tuner stops on the lowest memorized channel.
•When AUTO CH PROGRAM- MING is activated where there is
trol.
no TV signal input, “NO TV SIGNALS” will appear on the display after the completion of the channel scanning.
NO TV SIGNALS
•The unit may recognize CATV channels to be TV channels by the receiving conditions. In this case, try auto ch programming again in the fine receiv- ing conditions.
– 13 – | EN |