Emerson EWC20D5 A owner manual TV Operation, Watching a TV Program, Degaussing, Picture Control

WATCHING A TV PROGRAM

TV

1Turn on the unit

Hit [POWER] to turn on the unit.

2Select the channel number

Press [CH. K/L] to select your desired channel num- ber or press the number buttons.

Notes for using the number buttons on the remote control:

•You must precede single-digit channel numbers with a zero (Example: 02 ... 09).

•When selecting cable channels which are higher than 99, hit +100 first, then press the last two dig- its. (Example: to select channel 125, first hit +100, then press 2 and 5).

Remember:

¡If the unit is connected to a cable box or satellite box, the unit must be on CH3 or CH4, then the channel to be viewed must be selected on the cable box or satellite box.

3Adjust sound

Press [VOL. X/Y] to adjust the vol- ume.

VOLUME 20

C C C C C C C C C C C C C C C C

NOTE:

•If you press [CH. K/L] in the DVD mode, you can change the TV channels.

Even if you turn off the unit in the DVD mode, when you turn it on again, it will go into the TV mode.

DEGAUSSING

Magnetism from nearby appliances and speakers might affect the color of the TV picture.

If this happens, move this unit away from the appli- ance. If the color is still not correct, disconnect power cord from AC outlet then reconnect it after 30 minutes.

PICTURE CONTROL

TV

The unit’s picture controls – BRIGHT, CON- TRAST, COLOR, TINT and SHARPNESS – are preset to factory specifications. Although they are usually the best, you may need to make some further adjustments for a more natural looking image.

Make sure ...

•unit power must be turned on.

1Select “PICTURE CONTROL”

Hit [PICTURE] on the remote control.

2Select item you want to adjust

Press [K/L] until desired control is displayed.

BRIGHT CONTRAST COLOR

3Adjust the picture control

Press [s / B] to adjust to your desired level within 5 seconds.

NOTE:

•At step 3, the picture adjustment display will dis- appear from the TV screen after about 5 seconds unless you press any buttons, even though you may not be finished. In this case, repeat from step 1.

•If there is a power failure of any kind, the unit will retain its memory for this feature.