Emerson EWC20D5 A owner manual Deleting or Adding Channels

DELETING (OR ADDING)

CHANNEL(S)

TV

The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add the deleted channel into the memory again.)

1Select “CHANNEL SET UP”

Hit [SETUP] on the remote control. Press [K/L] to point to “CHAN- NEL SET UP”.

Then hit [ENTER].

- TV SETUP -

BCHANNEL SET UP V-CHIP SET UP LANGUAGE [ENGLISH] CAPTION [OFF]

2Select “ADD/DELETE CH”

Press [K/L] to point to “ADD/DELETE CH”. Hit [ENTER].

– CHANNEL SET UP –

BADD / DELETE CH (CATV) AUTO CH PROGRAMMING

3Enter the desired channel number

Press [K/L] until your desired channel number appears. (You can also press the number buttons or [CH. K/L] to enter it)

(Example: CH8)

08

ADD / DELETE

•

•

You must precede single-digit

channel numbers with a zero (Example: 02 ... 09). When selecting cable channels which are higher than 99, hit +100 first, then hit the last two digits. (Example: to select channel 125, first hit +100, then press 2 and 5).

4Delete (or add) it from (or into) memory

Hit [ENTER]. The channel number changes to light red. The channel is deleted from memory.

•To delete another channel, repeat steps [3] to [4].

•If you hit [ENTER] again, the channel is memo- rized again.

Added channel: Light blue

Deleted channel: Light red

5Exit the channel setup mode

Hit [SETUP] to return to TV mode.

NOTE: To confirm that channel(s) has been deleted or added, press [CH. K/L].

– 14 – EN