Grundig Scenos UMS 6400 DVD manual Connecting the antennas, Connecting the power cord

Page 18

CONNECTION AND PREPARATION_______________________________________

Connecting the antennas

R

TV

 

 

 

 

 

 

 

 

 

COAXIAL OUT

VIDEO OUT

 

 

 

 

 

 

 

 

R

 

 

L

 

 

FM ANT

 

 

 

AUDIO OUT

 

 

 

 

S VIDEO OUT

 

 

 

 

 

 

Y

Pb/Cb

Pr/Cr

 

 

 

 

 

COAXIAL OUT

VIDEO OUT

 

 

 

 

 

 

 

 

 

R

 

 

 

FM ANT

 

 

 

 

 

 

 

 

 

S VIDEO OUT

Y

P

 

 

 

 

 

 

 

 

 

AM ANT

 

 

 

 

 

 

 

 

 

EURO AV

TV

 

 

 

 

AM

A

 

 

 

 

 

 

 

LOOPANTENN

 

 

 

 

 

 

 

 

TO SUBWOOFER

FL

SL

SUB

 

 

 

1Plug the antenna cable of the rooftop antenna into the FM antenna socket » FM ANT«.

Note:

If no rooftop antenna is available, use the auxiliary antenna supplied. This antenna provides reasonably good reception of local FM (VHF) stations. Do not shorten the auxiliary antenna.

2For medium wave reception, plug the antenna cable of the supplied MW frame antenna in to the » AM ANT« socket.

Note:

In order to prevent interference, place the MW frame antenna as far as possible from the system.

SL

SUB

 

SR

CL

230 V~

50/60 Hz

 

RISK OF ELECTRIC SHOCK

 

DO NOT OPEN

 

ACHTUNG: GEHÄUSE NICHT ÖFFNEN STROMSCHLAGGEFAHR

 

AVIS: RISQUE DE CHOC ÉLECTRIQUE - NE PAS OUVRIR

230 V

50/60 Hz

Connecting the power cord

1Insert the plug of the DVD Micro System (»230 V~ 50/60 Hz«) in the socket.

Note:

If the DVD Micro System does not react when the buttons are pressed, this may be caused by electrostatic discharge in the area. In this case pull out the mains plug and insert it into the socket again after a few seconds.

2Insert the subwoofer power cord plug (»230 V~ 50/60 Hz«) into the socket.

Inserting batteries in the remote control

1Open the battery compartment by pressing the marked latch and lifting the lid.

2When inserting the batteries (Mignon type, 2 x 1.5 V, UM 3/R 6/AA) observe the polarity marked in the battery compartment.

3Close the battery compartment.

Note:

If the DVD Micro System no longer reacts properly to remote control commands, the batteries may be flat. Be sure to remove used batteries. The manufacturer accepts no liability for damage resulting from leaking batteries.

Environmental note:

Batteries, including those which contain no heavy metal, may not be disposed of with household waste. Please dispose of used batteries in an environmentally sound manner. Find out about the legal regulations which apply in your area.

18

Image 18
Contents DVD Home Cinema Micro System 29-30 Disc features Set-up and safety Overview20-26 Settings Scenos UMS 6400 DVD40-41 Timer mode 31-37 Disc mode38-39 Tuner mode 43-44 Additional settingsSpecial features of your DVD Micro System Packing contentsDolby Pro Logic, Dolby Digital and DTS SET-UP and Safety ON/OFF ECO SKIP/PRESET 8/DOWN Front of the DVD Micro SystemAM Tuner + VolumeFM Tuner DVDDVD S VCD MP3 Displays of the DVD Micro SystemRandom Back of the DVD Micro System From Main PowerOperating controls and connections of the subwoofer UnitRemote control Stop Tuning +DEMO/OK SlowEQ/BBS TimerRepeat LevelSurround right Front right Connection diagram for the loudspeakersSetting up the loudspeakers Surround left Centre Subwoofer Front leftConnecting the loudspeakers Connecting a television, a flat screen or a projectorConnecting external devices digitally Connecting an external 5.1 CH receiverInserting batteries in the remote control Connecting the antennasConnecting the power cord Environmental noteAdditional information for units sold in the UK Blue Neutral Brown LiveSetting the time General informationSelecting the menu language Setting the video functionsSetting the picture format Navigating in the set-up menuSetting the loudspeaker configuration Setting the colour norm for the televisionActivating loudspeakers Setting the distance to the listening position Center Speaker onMultiple channel settings Setting the audio functionsActivating digital audio signal outputs Setting the dynamic rangeSetting the surround mode Prologic Output OFFSetting and storing radio stations Inserting a disc Switching on and offAdjusting the volume Removing discsMuting Selecting sound settingsSetting the surround mode General information on disc playbackDVD features VCD/S-VCD featuresDisc formats Jpeg Picture CD features MP3/WMA CD featuresAudio CD features PBC playback controlInterrupting/resuming playback resume Playback functionsSelecting titles or chapters Step-by-stepUsing the DVD menu Selecting titles or chapters in DVD modePlayback with PBC playback control in Video CD mode Using the title menu of the DVDPlayback with progressive scan in DVD mode Displaying informationSlow motion Additional playback functionsFast search Enlarging the picture zoomZero setting GO to Switching the dubbed language or the audio formatSelecting and displaying subtitles Selecting and playing scenes Video CD and CD modeSetting bookmarks Playing back tracks or titles in random orderRepeat functions Deleting a programSelecting the waveband RDS station serviceSelecting the tuner input source Calling up stored radio stationsSwitching RDS information on and off Switching RDS time synchronisation on and offSearching for station types PTY » Tuning Switch-on timerSetting the switch-on timer » PROGRAM«Setting the sleep timer Sleep timerActivating and deactivating switch on timer Deactivating the sleep timerChanging the child lock settings Changing the parental lock access code»DEMO/OK « Setting the picture mode Displaying the multi-angle symbolActivating and deactivating the status line Setting the preferred subtitle language Language settingsSetting the preferred dubbing language Setting the preferred disc menu languageAmplifier Technical dataGeneral information Disc unitCleaning discs Loudspeakers Dimensions and weightGeneral instructions for laser devices Rectifying minor problems Fault Possible cause/remedy