APPENDIX
CONFIGURATIONS OF VGA TERMINALS
VGA IN (D-SUB) TERMINAL
Terminal :
Connect video output terminal of LCD TV to this terminal with VGA Cable (not supplied). When connecting Macintosh computer, the MAC Adapter (not supplied) is required.
Pin Configuration |
| 1 | Red Input | 9 | No Connect | ||||
|
|
|
|
| 2 | Green Input | 10 | Ground (Vert.sync.) | |
5 | 4 | 3 | 2 | 1 | 3 | Blue Input | 11 | Sense 0 | |
4 | Sense 2 | 12 | Sense 1 | ||||||
15 | 10 | 9 | 8 7 | 6 | |||||
14 | 13 | 12 | 11 | 5 | Ground (Horiz.sync.) | 13 | Horiz. sync. | ||
|
|
|
|
| |||||
|
|
|
|
| 6 | Ground (Red) | 14 | Vert. sync. | |
|
|
|
|
| 7 | Ground (Green) | 15 | Reserved | |
|
|
|
|
| 8 | Ground (Blue) |
|
| |
MAC ADAPTER (Not Supplied)
Set slide switches as shown in the table below depending on RESOLUTION MODE that you want to use before you turn on LCD TV and computer.
Slide Switches
ON
ON DIP
1 2 3 4 5 6
OFF
| 1 | 2 | 3 | 4 | 5 | 6 |
13" Mode (640x480) | ON | ON | OFF | OFF | OFF | OFF |
16" Mode (832x624) | OFF | ON | OFF | ON | OFF | OFF |
19" Mode (1024x768) | OFF | ON | ON | OFF | OFF | OFF |
|
|
|
|
|
|
|
SIGNAL MODE COLUMN (Recommended)
This LCD TV can correspond to the signals below. After connecting with the computer, LCD TV can automatically recognize the signal from the connected PC( computer)/ HDMI.
PC SIGNAL MODE COLUMN (recommended)
Note:
●In case LCD TV can not display properly due to the connecting cable or the graphic hardware, please make adjustments about phase, clock and so on.
●In principle, LCD TV can not display the signal mode which not described in the above column. But sometimes it can display a signal very similar with one of the signal described.
●If you want to change the definition and colour of PC, please select one from the column.
●It is not the trouble of LCD TV if interference appears on the picture while switching the signal mode.
●It is different from CRT Monitor that it is no blink of the picture when the
●The Dot Clock of the computer's signal must be less than 100 MHz.
●Specifications are subject to change without notice.
In case of the following things, some messages will display on the screen.
● When the input signal from PC is out of the display range, "OUT OF RANGE" will display.
47
1/21/2010 10:47:32 AM