Sharp LC-46LE530X Digital audio output, Audio only, Game play time, DivX R Reg. Code, Version up

Option menu (Continued)

■Digital audio output

This function allows you to select your favourite audio output system.

Selected item	Description
PCM	The optical output format is normally in
	PCM.
	Dolby Digital audio will be output when
Dolby Digital	there is a Dolby Digital audio signal. The
	output will be in PCM when there is no
	Dolby Digital audio signal.

■Audio only

When listening to music from a music programme, you can set the display off and enjoy audio only.

Selected item	Description
On	Audio is output without screen image.
Off	Both screen images and audio are
	output.

NOTE

•When you make operations that change the picture on the TV such as by changing the input source, the Audio only function is set to “Off”.

■Game play time

This function displays the elapsed game time so you do not lose track of the time.

To display the elapsed time, select “GAME” under

“AV mode” for the input mode of the terminal connected to the game console before starting the game.

Selected item	Description
	The elapsed time is displayed every
On	30 minutes when you switch to GAME
	mode in external input mode.
Off	Hides the time.

■Colour system

You can change the colour system to one that is compatible with the image on the screen (Auto, PAL, SECAM, NTSC 3.58, NTSC 4.43, PAL-60).

NOTE

•If “Auto” is selected, colour system for each channel is automatically set. If an image does not display clearly, select another colour system (e.g. PAL).

•“Colour system” is selectable only when inputting a composite signal.

■DivX (R) Reg. Code

Please see page 29.

■Version up

This function is only for service personnel to use for software updates.

■Fine sync. (PC input mode only) Adjusting the PC image automatically

Auto sync.

This function enables the screen to be automatically adjusted to its best possible condition when the analogue terminals of the TV and PC are connected with a commercially available RGB cable, etc.

NOTE

•Auto sync. is likely to succeed when an input PC image has wide vertical stripes (e.g. pattern with high contrast stripes, or cross-hatched).

It may fail when an input PC image is solid (low contrast).

•Be sure to connect the PC to the TV and switch it on before starting Auto sync.

Adjusting the PC image manually

Ordinarily you can easily adjust the picture as necessary to change image position using Auto sync. In some cases, however, manual adjustment is needed to optimise the image.

Selected item	Description
H-Position	Centres the image by moving it to the left
	or right.
V-Position	Centres the image by moving it up or
	down.
Clock	Adjusts when the image flickers with
	vertical stripes.
Phase	Adjusts when characters have low
	contrast or when the image flickers.

NOTE

•For resetting all adjustment items to the factory preset values, press a/b to select “Reset”, press ENTER, press c/d to select “Yes”, and then press ENTER.

•Images may not be displayed properly depending on the settings and/or input signals.

Input signal

•Some input signals may have to be registered manually to display properly.

•The pairs of input signals (resolutions) in the list below are not distinguishable when received. In such case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.

1280 g 768 1360 g 768

17