Parental rating, Input skip, Input label

Setup menu (Continued)

Parental rating

This function allows TV channels to be restricted. It prevents children from watching violent or sexual scenes that may be considered inappropriate.

1Repeat steps 1 to 3 in Setting a password.

2Press a/b to select “Parental rating”, and then press ENTER.

3Press a/b to select your desired rating, and then press ENTER.

When the country setting is set to “Australia”.

	Selected item	Description

	General and	Content is not offensive to most viewers.
	above (G)	Content is not offensive to most viewers.
	above (G)

	Parental	Content is such that parents may
	guidance and	not want their children to view the
	above (PG)	programme.
		Mature audience only. This programme
	Mature and	is specifically designed to be viewed by
	above (M)	adults and therefore may be unsuitable
		for children under 15.

		Mature adult only. Mature audience only.
	Mature adult	This programme is specifically designed
	and above (MA)	to be viewed by adults and therefore
		may be unsuitable for children under 15.

	Adult violence	Not for children under age 15. Strong
	and above (AV)	elements of sex and/or violence.

	Restricted and	Not for children under age 18. Strong
	above (R)	elements of sex and/or violence.
	No block (–)	Cancel the blocking.

When the country setting is set to “New Zealand”.

Block 5 age and below

Block 11 age and below

Block 13 age and below

Block 15 age and below

Block 17 age and below

Block 18 age and below

No block

■Input skip

This setting allows you to skip the HDMI or PC input on the input source selection operation.

HDMI1

Skip input selection of HDMI

HDMI2

HDMI3

YesNo

■Input label

You can assign each input source a label as you prefer.

1Press INPUT to select the desired input source.

2Press MENU and the MENU screen displays.

3Press c/d to select “Setup”.

4Press a/b to select “Input label”, and then press

ENTER.

5Press a/b/c/d to select a desired alphanumeric, and then press ENTER.

Repeat until the name is fully spelt out. Maximum 6 alphanumeric can be input.

External equipment name settings

A B C D E F G H I J CLEAR

KLMNOPQRST BACK

U V W X Y Z + – . _

0 1 2 3 4 5 6 7 8 9

END

To exit, select END and then press ENTER. If the wrong alphanumeric is entered, select CLEAR to clear, and then press ENTER.

NOTE

• You cannot change labels if the input source is ATV and DTV.

■Position

For adjusting a picture’s horizontal and vertical position.

	Selected item	Description

	H-Position	Centres the image by moving it to the left
	H-Position	or right.
		or right.

	V-Position	Centres the image by moving it up or
	V-Position	down.
		down.
	Reset	Reset position to factory preset values.

■HDMI auto view (HDMI input mode only)

Selected item	Description

	Set whether or not to use WIDE MODE
Enable/Disable	based on signal recognition, including an
	HDMI signal.

■WSS

WSS allows a television to switch automatically among the different screen formats (On, Off).

NOTE

•Try to set WIDE mode if an image does not switch to the correct screen format. When the broadcast signal contains no WSS information, the function will not work even if enabled.

•Not available for COMPONENT, PC and HDMI signal.