If your DTR fails to respond
Invery exceptional circumstances, yourDTR maynotrespond as expected when switchingit on. If this does happen, it is most likely to have been caused by corruption of programmes stored on your disk. This can occasionally cause the DTR to remain in standby mode or fail to respond to the remote control while not displaying any picture. However, normal DTR operation can usually be restored, by performing a reset as noted below.
WARNING
Resetting your DTR can cause all saved programmes to be lost.
These steps should only be taken after carefully checking all DTR connections and ensuring you have working batteries in your DTR remote control.
Check the display on the front panel of your DTR.
Scenario 1 – No display
•Check the mains lead is properly inserted to the back panel.
•Check the wall socket works by plugging in another appliance.
•Check the fuse in the plug. Only replace with a 5A fuse complying with BS1362. Ask an electrician for help if you are not sure what to check.
Scenario 2 – Solid red LED and no display
This means the DTR has encountered an error but it can usually be restored. The following sequence will restore the settings of your DTR to the factory default and will retain your saved programmes.
•Unplug the mains power or switch off your DTR at the wall socket.
•Wait 5 seconds.
• Restore the power while pressing and holding the front panel |
|
| button for 5 seconds. |
|
| ||
PLS WAIT and then REVERT will be displayed. |
|
|
|
•Wait 45 seconds for the DTR to complete the reset procedure.
•Select the DTR input on your TV and check for picture.
Scenario 3 – Solid red LED and PLS WAIT continuously displayed
This means the DTR has encountered an error and cannot be easily restored. The following sequence will restore the settings for your DTR to the factory default and also delete all saved programmes from the internal storage.
•Unplug the mains power or switch off your DTR at the wall socket.
•Wait 5 seconds.
•Restore the power and wait until the message ‘PLS WAIT’ disappears from the display then press the front panel button. Wait until ‘FORMAT’ message is displayed and then release the button.
•Wait 45 seconds for the DTR to complete the reset procedure.
•Select the DTR input on your TV and check for picture.
Information
33