A Unplug the aerial cable from your VCR (or TV) and plug it into the Aerial In socket of your DTR.
BUsing the SCART lead, connect the TV SCART socket on your DTR to the AV1/EXT1/AUX1 SCART socket at the back of your TV.
CConnect the mains lead to the mains socket and switch on at the mains. Reconnect the power to all your existing equipment and turn your TV on.
When you plug your DTR into the power supply, a red light and the message PLS WAIT will be displayed. This will be followed by WELCOME TO TOP UP TV+, the HDD symbol will flash for about 45 seconds. You must wait for the HDD symbol to stop flashing and the display to go dim before pressing any buttons.
Step 3 – Your DTR is ready to scan for channels
Press the DTR button on your remote. The button will momentarily flash. This will confirm that the remote control is working correctly. Now wait for the light on the front of your DTR to turn from red to green.
Your TV should now automatically switch to the DTR input and display the image shown. If this does not happen, using your TV remote, manually select the TV SCART input to which you have connected your DTR. Refer to your TV handbook if required, but it is likely that the TV remote button will be labelled ‘AV’ or have this symbol 
Once you can see the image on screen displayed here, and have ensured all connections are correct, press OK on your remote control.
Getting Started
7