Vanguard Managed Solutions PRVYS18PWA Installing Logs, For Vintage Oak Model, Vanguard Flame-Max

VANGUARD FLAME-MAX®

UNVENTED PROPANE/LP GAS LOG HEATER

INSTALLATION

Continued

INSTALLING LOGS

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.

For Vintage Oak Model

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 17).

2.Locate the notches on the back of the front log (#2). Slide these notches over the tabs of the grate base (see Figure 18).

3.Locate the notches in the bottom of the crossover log (#3). Place the crossover log on top of the back log and front log. Make sure the notches of the crossover log line up with rectangular knobs on top of the back and front logs (see Fig- ure 19).

4.Add lava rock around base of heater.

Back Log (#1)

Peg

Hole

Peg

Figure 17 - Installing Back Log

Front

Log (#2)

Notch

Tabs of

Grate Base

Figure 18 - Installing Front Log

Crossover	Notch
Log (#3)

Rectangular

Knob

Notch

Rectangular

Knob

Figure 19 - Installing Crossover Log

For Golden Oak or Birch Models

It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place one-piece log set on grate to fit as illustrated in Figure 20. Make sure middle section at bottom of log set is seated into “U”-shaped cutout in cen- ter of chassis (see Figure 20). Note: 36” and birch models have more features but fit on the chassis the same. Log will fit securely on chassis. IMPORTANT: Make sure log does not cover any burner parts.

2.Place lava rock around base of heater.

One-Piece

Log Set

Middle Section at Bottom of Log Set

Chassis

Burner

“U”-shaped Cutout

in Chassis

Figure 20 - Installing Golden Oak or Birch One-Piece Log Set

Burner

One-Piece

Log Set

Figure 21 - Installing Golden Oak or Birch One-Piece Log Set (Top View)

14 104343