TV menu
EEAssign a channel decoder (For ATV)
Decoders that decode channels can be connected to SCART. You have to assign the TV channel as a channel to be decoded. Before selecting channels, make sure your TV is connected to SCART.
1.Press MENU on the remote control and select TV ≥ Channels.
NOTE
•You are prompted to enter current password to enter
Channels if Channel Block /Parental Guidance /
Input Block in the Parental menu is not the default setting.
2.Press <> to select Decoder and press OK or ≥ to enter available analogue channel list.
3.Press <> to select the channel to decode.
4.Press OK to mark or cancel.
5.Follow the
EEAnalogue Ch Fine Tune
You can manually fine tune analogue channels when reception is poor.
1.Press MENU on the remote control and select TV ≥ Channels.
NOTE
•You are prompted to enter current password to enter
Channels if Channel Block / Parental Guidance /
Input Block in the Parental menu is not the default setting.
Features
Select menu language
Select the menu display language.
1.Press MENU on your remote control and select Features ≥ Menu language.
2.Press ≤≥ to select your language.
3.Follow the
4:3 Mode
Select aspect ratio behavior for Auto mode. When 4:3 is selected, the picture size will follow WSS or Scart Pin8 Spec. If 16:9 is selected, the picture format will change to wide screen.
1.Press MENU on your remote control and select Features ≥ 4:3 Mode.
2.Press ≤≥ to select the mode your preferred.
3.Follow the
Change picture format
Change the picture format to suit your content.
1.Press ∏ repeatedly to select one of the following picture formats. Alternatively, press MENU and select Features > Picture Format.
2.Press <> to select Analogue Ch Fine Tune and press OK or ≥ to enter the analogue channel list.
3.Press <> to select one channel and press OK to enter.
4.Press ≤≥ to adjust the frequency.
5.When complete, press OK to set the frequency. The fine tuned channel is stored under the current channel number.
6.Follow the
EEClean Channel List
Select to clean all the channels that stored in the channel list.
1. Press MENU on the remote control and select |
Auto |
The Automatic format for DTV transports streams with AFD information, while for ATV and SCART should be with WSS information.
TV ≥ Channels. |
NOTE
•You are prompted to enter current password to enter
Channels if Channel Block /Parental Guidance /
Input Block in the Parental menu is not the default setting.
2.Press <> to select Clean Channel List and press OK or ≥ to enter.
3.Select OK and press OK on the remote control to clean channel list.
Normal (Not for HD)
Displays the classic 4:3 format.
NOTE
•Constant use of the Normal picture format can cause screen distortion.
16