Sharp LC-26SH330E, LC-42SH330E Special Note for Users in the U.K, Blue Neutral Brown Live

Page 34

SPECIAL NOTE FOR USERS IN THE U.K.

The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 5A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or ASA and of the same rating as above, which is also indicated on the pin face of the plug, must be used.

Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.

In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off the mains plug and fit an appropriate type.

DANGER:

The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner.

Under no circumstances should the cut-off plug be inserted elsewhere into a 5A socket outlet, as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:

IMPORTANT:

The wires in the mains lead are coloured in accordance with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black.

The wire which is coloured brown must be connected to the plug terminal which is marked L or coloured red.

Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three-pin plug.

Before replacing the plug cover make sure that:

If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug.

The cord grip is clamped over the sheath of the mains lead, and not simply over the lead wires.

IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

( 91.6) / [ 91.1] / {97.1}

( 91,6) / [ 91,1] / {97,1}

( 389.8) / [ 389.8] / {503.8}

 

 

 

 

 

 

 

 

( 389,8) / [ 389,8] / {503,8}

 

 

 

( 67.9) / [ 67.9] / {90.9}

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

( 67,9) / [ 67,9] / {90,9}

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

( 657.8) / [ 790.5] / {1015.3}

 

 

 

 

 

 

 

( 657,8) / [ 790,5] / {1015,3}

 

 

 

 

 

 

 

( 578.0) / [ 700.6] / {933.5}

 

 

( 239.8) / [ 239.8] / {269.8}

{705.8}

{705,8}

{654.6}

{654,6}

{526,2}/

 

( 239,8) / [ 239,8] / {269,8}

 

{526.2}/

 

 

 

 

 

 

( 578,0)

/ [ 700,6] / {933,5}

 

 

 

( 491.1) / [ 569.8] / ( 491,1) / [ 569,8] /

( 448.4) / [ 526.8] / ( 448,4) / [ 526,8] /

 

( 326.0) / [ 395.3]

( 326,0) / [ 395,3]

325.2] / {398.8}

325,2] / {398,8}

 

 

 

 

 

 

 

( 286.2) / [ ( 286,2) / [

 

 

/ {51.2} / {51,2}

 

32”

42”

 

 

 

( 42.7) / [ 43.0] ( 42,7) / [ 43,0]

 

 

 

 

 

 

 

 

 

 

 

 

 

 

[ 200.0] / {200.0} [ 200,0] / {200,0}

 

 

 

 

 

 

 

( 200.0)

 

 

 

 

 

 

 

 

( 200,0)

 

 

 

 

26”

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

[ 200.0] / {400.0}

 

 

 

 

 

 

( 100.0)

( 100,0)

[ 200,0] / {400,0}

 

 

 

 

 

 

 

(

) :

26"

[

] :

32"

{ }: 42"

Image 34
Contents LC-26SH330E / LC-32SH330E LC-42SH330EContents Introduction Important Safety PrecautionsPrecautions when transporting the TV Dear Sharp customerRemote control unit TV Front view RS232C-connectorRS232 connector is only used for service purpose TV Rear viewMount the TV base Supplied accessoriesPreparation Wall mountingSelect an item by the remote control Installation of batteriesUsing the remote control Display the Menu ScreenQuick guide Initial installation overviewPower on and run the auto installation PreparationTuner mode setting Watch TVTV indicator status Standby modeWatching TV EPG Electronic Programme Guide Switch on EPGPress EPG or Exit to exit Buttons for teletext operations Using the MHEG5 application UK onlyTeletext Select a Teletext languagePicture TV menuSound EEUpdate Scan Use Sound ModeAutomatically install channels Select a digital audio languageMenu EEAnalogue Manual Scan EESingle RF ScanEEFavourite Network Select EEChannel Edit EEChannel SkipEEChannel Sort Channel sort allows you to reorder the channelsFeatures Normal Not for HDZoom 2 Not for HD Zoom 1 Not for HDWide EESet analogue subtitles EEAutomatically switch the TV to standby Sleep timerUse subtitles EESelect a subtitle language on digital TV channelsDivX Setup EEDivX Registration VOD No Signal OffReset Default Hdmi overscanParental Repeat to 4 to change password Set / Change passwordClear all parental settings Reset all the settings in the Parental menuEEView Photos Connecting a USB deviceUSB function EEBasic OperationEEListen to Music USB device compatibilityEEPlay Videos YPbPr Component connection Connecting external devicesHdmi connection Scart connectionInserting the Smartcard into the CA module Speaker / Amplifier connectionChecking CA module information Video formats Connecting a PCAnalogue connection Appendix TroubleshootingProblem Possible Solution Hair dryersSpecification STEREO/BILINGUAL NICAM/A2Environmental specifications Other informationSoftware developed by Sharp and open source software TrademarksAcknowledgements Other Countries outside the EU Information on Disposal for Business Users European UnionPage Special Note for Users in the U.K Blue Neutral Brown Live