Speaker / Amplifier connection

Connecting external devices

Example of connectable devices

EVCR EDVD recorder

EWhen using the SCART 2

Half SCART, which transmits S-Video or CVBS in, and CVBS monitor out.

VCD / DVD recorder

SCART cable

32” 42”

NOTE

•In cases when the decoder needs to receive a signal from the TV, make sure to select the appropriate input source.

•Do not connect the decoder to the SCART 2.

•You cannot connect the VCR with Decoder using a fully wired SCART cable under the SCART 2 source.

EConnecting an amplifier with digital audio input / analogue audio input

Speaker / Amplifier	Digital audio in
connection	(COAXIAL)

Digital audio cable

AUDIO IN

L R

Audio cable

26”

32” 42”

26” 32” 42”

Inserting the Smartcard into the CA module

In order to receive coded digital stations, a conditional access module (CA module) and a Smartcard must be inserted in the CI (Common Interface) slot of the TV.

The CA Module and the Smartcard are not supplied accessories. They are usually available from your dealer.

Inserting the Smartcard into the CA Module

1.Carefully insert the CA module in the CI slot with the contact side forward.

2.The logo on the CA module must be facing outward from the rear of the TV.

NOTE

•It takes about 30 seconds to certify the license key when you insert a Smartcard into the CI+ compatible CA module for the first time. This process may fail when there is no antenna input or you have never run “Auto installation”.

•The CI+ compatible CA module sometimes upgrades its firmware. You may not receive any TV images before upgrading. You can only use the power button during upgrading.

•The CI+ compatible CA module does not allow you to output any copy protected programmes using monitor out.

•If the TV displays an update confirmation message for the Smartcard while receiving CI+ compatible broadcasts, follow the screen prompts.

•Make sure that the CA module is properly inserted.

Checking CA module information

After inserting and activating the CA Module, make sure the input source is TV.

1.Press MENU on the remote control.

2.Go to Features > Common Interface.

NOTE

•This menu is only available for digital stations.

•The content of this menu depends on the provider of the CA module.

Module

General information on CA module displays.

Adjustment parameters of each Smartcard displays.

Enquiry

You can input numerical values such as passwords here.