PIP 2 Tuner Picture In Picture | Sharp 32N-S500 guide

PIP (2 Tuner Picture In Picture)

LUsing the various video input or the second tuner, you can watch two programs at the same time.

During airing of commercial messages, you can watch other program by using the CM SKIP function.

LTo view the Inset Picture. Press PIP.

(Press the button to turn the Inset Picture on and off).

Main Picture

Insert

Picture

LChannel Display when PIP is ON (4 seconds). Example:

Main Picture — Channel 12 Inset Picture — Channel 6

Channel display	1 2	Channel display
	6	for main picture
for inset picture

LTo select the channel or input mode for the Inset Picture.

•If you want to change the channel or input mode, then press SELECT to move the “ :” mark to channel display “SUB.”.

1 2

Press INPUT.

(Each time you press the button, the picture will change as shown below.)

POWER

TV	VCR	INPUT
	VCR	INPUT
			INPUT
PIP	CM SKIP DISPLAY		MUTE
PIP			CM SKIP
SWAP	FREEZE	MOVE	SELECT
SWAP			SELECT
FREEZE			MOVE

LTo swap the Main and Inset Pictures.

•Press SWAP.

(Press the button to swap the pictures again.)

Example:

1 2

Main Picture n 12CH

Inset Picture n INPUT1

Push SWAP.

I N P U T 1

Main Picture n INPUT1

Inset Picture n 12CH

LTo move the Inset Picture. Press MOVE.

(Press the button again to move the Inset Picture to another position.)

LFreeze-Frame Inset Pictures.

•When the Inset Picture is on the screen, press the FREEZE to freeze the Inset Picture.

Only when the Main Picture is on the screen, press the FREEZE to inset a freeze-frame of the Main Picture.

•Press FREEZE again to remove the Inset Picture.

1 2

LCommercial Skip Function

•Use this function when you want to scan other channels during a commercial break.

(1)When a program break occurs, press CM SKIP. Then Main Picture move to the Inset Picture. (While you are watching other channels you can check the Inset Picture.)

(2)Press CM SKIP when the program in Inset Picture starts again. Then Inset Picture moves to Main Picture.

NOTE:

•When the Main Picture’s signal is black and white or the signal is lost, the Inset Picture may change to black and white. In this case, the Inset Picture may appear with a bit of vertical jagged lines depending on the type of receiving signal.