Operation of Remote Control (Continued)
POWER | VCR POWER |
TV | INPUT |
VCR |
| 1 |
| 2 |
| 3 |
|
REMOTE | 4 |
| 5 |
| 6 |
|
KEYPAD | 7 |
| 8 |
| 9 |
|
|
|
|
| |||
| FLASHBACK |
| ENTER |
| ||
|
|
| 0 | 100 |
| |
| PERSONAL PREFERENCE |
| ||||
A | B | C |
| D |
| |
| VOL | CH |
| VOL |
| |
|
|
|
|
| ||
| — | CH |
| + |
| |
|
|
|
| CHANNEL | ||
|
|
|
|
|
| |
|
|
|
| MENU | UP (8)/ | |
|
|
|
| CATV TV | DOWN (9) | |
|
|
|
|
|
|
|
| REW | PLAY |
| FF |
|
|
PAUSE | STOP |
| REC | VCR CH |
| |
|
|
| ||||
| PIP | CM SKIP DISPLAY | MUTE |
| ||
| SWAP | FREEZE | MOVE | SELECT | DISPLAY | |
LHOW TO IDENTIFY A VCR
The remote control may already be set to operate your VCR. Try this initial check to see if going on to the following “identify” section is necessary.
(1)Point remote towards VCR and press VCR POWER.
(2)Does the remote turn the VCR ON and OFF?
•If yes, the remote is ready to operate the VCR and no further steps are needed.
•If no, continue to the “identify” section.
LTo Identify Your VCR – Direct Entry Method.
Use the following steps and list on page 29 to quickly find the remote control code for your accessory VCR.
•First look up your VCR’s remote control code number before going through the direct code entry steps control.
•If this procedure does not identify your accessory VCR, use the Search method of identification (described in the next section).
(1)Slide
(2)Press and hold down DISPLAY and CH DOWN (9) on your remote control.
Then release both buttons.
(3)Within ten seconds after releasing DISPLAY and CH DOWN (9), enter your VCR’s
REMOTE KEYPAD (refer to list).
•The remote control is now ready to send commands to your VCR.
Some brands have more than one remote code listed, due to changes in the remote codes from early to later model years, or due to format differences (VHS/BETA). In such cases, you may have to try more than one code to find the code your VCR accepts.
NOTE:
Depending on the model, year produced, brand, and type of VCR, some models may not be compatible with the remote control.
LTo Identify Your VCR – Search Method.
(1)Slide
(2)Press POWER on the VCR to ON.
(3)Stand at least six feet away from the front of the VCR. Point the remote towards the VCR.
Hold down DISPLAY and CH UP (8) at the same time. Keep holding the buttons down.
(4)Watch the Channel Number indicator on the VCR. Channel numbers will scan up when the VCR has been identified. Release DISPLAY and CH UP (8) as soon as the channel numbers start to scan up.
The VCR’s remote control code number has been identified, and the remote is ready to operate the VCR.
28