Using the Audio Output Jacks
LThese jacks are used for connecting a standard studio amplifier. Control of STEREO/MONO/SAP, BASS, TREBLE, BALANCE, VOLUME and MUTE are retained at the TV. These jacks relay the audio signal of all programs being displayed on the TV screen.
(AUDIO OUTPUT JACKS are located on the rear of the cabinet).
CONNECTIONS
(Rear connection terminals of TV)
is a trademark of SRS Labs, Inc.
Either the
LINE IN | LINE | |
IN 1 | IN 3 | OUT |
|
|
|
S-VIDEO
IN 1 | IN 3 | ||||
|
|
|
|
|
|
|
|
|
|
|
|
VIDEO
L
AUDIO
R
To the audio Input terminals
Stereo amplifier
Speaker System
(1)Before connecting the cord, turn on the TV and adjust the VOLUME control on the TV for a moderate listening level.
(2)Turn off the TV and connect the audio cord to the AUDIO LINE OUTPUT JACKS on the TV.
(3)Turn the TV set and stereo amplifier on.
(4)If you desire, you can turn off the sound to the TV’s internal speakers by SPEAKER mode. See pages 13 - 14.
(5)Adjust the VOLUME control on the stereo amplifier for a moderate listening level.
(6)Control of the audio can be done using the audio controls (STEREO/MONO/SAP, VOLUME, SRS, EQUISOUND and MUTE), from either the remote control, or directly from the TV set.
NOTE:
•For detailed information on the connection and use of auxiliary equipment, refer to the operation manuals of the equipment being used.
•When connecting monaural equipment to the AUDIO INPUT or OUTPUT of this set, use an audio connection cord and plug adapter as shown below.
•For optimal sound quality, it is recommended to keep the TV’s audio output level high.
|
| Plug adapter |
To the TV |
| To the equipment |
| being connected | |
|
| |
Pin plug x 2 | Pin plug | Pin jack/Mini plug |
26