Sharp DV-RW370X Installing batteries in the remote control, About the remote control

Page 10

Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two AA (R6) size batteries (supplied) into the remote control, carefully match with the polarity indicated inside the battery compartment.

1

2

3

Caution

•Incorrect use of batteries can result in hazards such as leakage and bursting.

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together.

•Make sure that the plus and minus ends of each battery match the indications inside the battery compartment.

•Remove batteries if the equipment will not be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or the public instructions for environmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

•Comply with the rules (ordinance) of each local government when disposing of worn-out batteries.

10 EN

About the remote control

•Make sure there is no obstacle between the remote control and the remote control sensor on the unit.

•Use within the operating range and angle as shown.

•The maximum operable range as follows:

DV-RW370

 

OPEN/CLOSE

 

 

 

STOP/EJECT

PLAY

 

VCR

STOP

PLAY

OPERATE

 

 

DVD

 

REW F.FWD

REC/OTR

 

 

 

REC/OTR

 

PROGRAMME

 

 

 

 

 

(TRACKING)

DUBBING

OUTPUT SELECT

 

OPERATE

OPEN/CLOSE

 

 

DUBBING SETUP EJECT

 

T-SET

TIMER PROG. REC MODE RAPID PLAY

 

Line of sight:

 

approximately 7m

Either side of centre:

approximately 5m

Above:

 

within 30 degrees

 

approximately 5m

Below:

 

within 15 degrees

 

approximately 3m

 

 

within 30 degrees

•Remote control operation may become unreliable if the remote control sensor of the unit is being exposed by the strong sunlight or fluorescent light.

•Remote controls for different devices can interfere with each other. Be careful when using remote controls for other equipment located close to the unit.

•Replace the batteries when the operating range of the remote control reduces.

Child Lock function

This function protects any unexpected operations by the kids when recording important programme and so on.

1

Press and hold [RETURN / ] for more than 5 seconds.

“LOC” will be displayed on the front panel display and the Child lock is now activated.

•If any buttons (except for [RETURN / ]) on the remote control or the unit are pressed, “” will appears on the TV screen.

2

Press [RETURN / ] again for more than 5 seconds.

“LOC” disappears and the Child lock will be released.

Note

•When One-touch Timer Recording or Timer Recording has finished or if the power failure occurs during Child lock is activated, the function will be released.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Region number for This unit isSupplied Accessory PrecautionsPower Cord Protection Nonuse PeriodsCopyright Precautions cont’dLocation and Handling Copy ProtectionAuto Head Cleaning Cleaning the CabinetCleaning Discs ServicingTable of contents Playback FeaturesSymbol Description CompatibilityFunctional overview 8* 9*10 13 14 16 17*18 19 20Functional overview cont’d Remote ControlRear Panel REV E / r button VCR / DVD DVD mode CLEAR/C-RESET button VCR / DVD DVD modeVCR mode Audio button VCR / DVD DVD modeAbout the remote control Installing batteries in the remote controlChild Lock function DVD Mode VCR/DVD recorder SwitchingVCR Mode Guide to On-Screen DisplaysPlayback Setup menusRequired Setting DisplayDisplay message Front Panel Display GuideVCR functions Others 14 EN Connecting to a TVBasic TV connection VCR and Basic DVD ConnectionEditing Setup menu Connecting to a TV cont’dConnecting to external equipment AV3 FrontConnecting to an Audio System 16 ENThis unit can record on the following type of discs Turn on the unit Select the DVD mode Open the disc trayEasy DVD recording Ing, select the rewritable DVD-RW type discMode Channel Easy DVD recording cont’dChannel setting Auto TuningSelect Manual Tuning using Cursor K / L, then press Enter Channel setting cont’dManual Tuning After completion, press Setup to exitTo select a channel To skip a Preset channelMove Select Clock Setting using Cursor K / L, then press Enter Setting the clockClock Setting Default date will appearEnter Type of discs Recording modeInformation on DVD recording Recordable discsMaking discs playable in other DVD players Finalise Information on DVD recording cont’dInformation on copy control Usable discsChoosing the recording format of a brand-new DVD-RW disc Select Format Mode using Cursor K / L, then press EnterFormatting a disc Formatting is completedRecording Audio Select XP Setting Auto ChapterFormatting a disc cont’d PCMReformatting a disc manually Insert a recordable disc Stop mode, press SetupIf you want to cancel formatting, select No Popup window will appear and prompt you to confirmSetting External Input Audio Setting Bilingual Recording AudioBasic recording / One-touch Timer Recording OTR Timer Recording To stop the timer recording in progress Timer Recording cont’dIf the timer programming did not complete correctly If the starting time is same Hints for Timer RecordingPriority of overlapped settings If the recording time is partially overlappedPreparation on this unit Select Satellite Link using Cursor K / L, then press EnterSatellite Link Press EnterSatellite Link cont’d Settings for external equipmentRecording from external equipment DV dubbing Guide to DV and On-Screen DisplayDV dubbing cont’d Recording menu will appear Dubbing ModeSelect Dubbing Mode using Cursor K / L, then press Enter Option window will appearPress Dubbing Select VCR DVD using Cursor K / L, then press EnterSelect DVD VCR using Cursor K / L, then press Enter Press Stop C to stop the recordingFinalising discs To cancel the disc protectSelect Finalise using Cursor K / L, then press Enter 40 ENYou start Connections FinalisingXXXXdiscscont’dcont’dAuto finalise Getting started RecordingColour systems Information on playing back DVDsPlayable discs Region codesPlaying back a DVD-RW / DVD-R / DVD+RW / DVD+R disc Hint for DVD playbackPress Stop C to stop play- back Playing back a DVD-Video / CD / Video CD Basic playback cont’dPlaying back an MP3 / Jpeg Playing back a DivX Hint DivX Official DivX Certified productPress Menu List Playing back discs using the Disc menuSelect an item using Cursor B, then press Disc menuPlaying back a Video CD using the Title menu Playing back a disc using the Title menuPBC function for Video CDs Special playback Cancelling and Recalling the PBC functionPBC function for Video CDs cont’d Resume playbackSkipping TV commercials during playback Special playback cont’dFast forward / Fast reverse CM SkipDuring playback, press Pause F PauseRapid Play Press Play B to resume play- back52 EN Step by step playbackSlow forward / Slow reverse playback PauseZoom Marker SetupSelect the icon using Cursor / B, then press Enter During playback, press DisplayTrack search SearchTitle / Chapter search DisplayDirect Search Search cont’dTime search Repeat/Random/Programme playback / Slide Show Repeat playbackRepeat/Random/Programme playback / Slide Show cont’d CD Playback Mode menu will appear Audio CDSelect Random Play using Cursor K / L, then press Enter Random playbackProgramme playback Slide ShowSelect Playback using Cursor Switching subtitlesSelect DivX VOD using DivX VODSwitching virtual surround system Switching audio soundtrackSelecting the format of audio and video cont’d Reducing block noise Switching camera anglesIcon using Select Cursor / B, then pressGuide to a title list Original and Playlist VR modeInformation on disc editing Edit the recorded discDVD-RW Information on disc editing cont’dEditing discs DVD-RDeleting titles Select Title Delete using Cursor K / L, then press EnterEditing discs Press Return or Stop C to exitEditing title names Select Edit Title Name using Cursor K / L, then press EnterEditing discs cont’d Press Return and then Return or Stop C to exitGuide to edit title name Abc 123Confirmation window will appear. e.g. Add Select Chapter Mark using Cursor K / L, then press EnterAdding or deleting chapter marks DeleteDeleting a chapter mark Adding a chapter markChapter mark is added Chapter mark is deletedSetting pictures for thumbnails Picture is set as the thumbnailSelect Scene Delete using Cursor K / L, then press Enter Deleting a part of a titlePart of the title is deleted Select Delete using Cursor K / L, then press EnterOr Playlist is more than Dividing a title You can divide a title into two new titles Press firstYou can combine two titles into a single title Press first Select Title Combining using Cursor K / L, then press EnterCombining titles If either one of the twoAdding titles to a Playlist Follow the on page 64 to display the PlaylistPlaylist is deleted Select Yes using Cursor s / B, then press EnterErasing all Playlist Deleting a Playlist will Not increase the availableTo protect a whole disc DVD-RW VR mode Only Setting or releasing the title protectionSelect Protect using Cursor K / L, then press Enter Confirm the indication OFF ON. Press Enter againYou cannot select a chapter Setting or clearing all chapter marks in one titleChapter marks are added Mark interval that exceedsTour of the Setup menu 78 ENAudio Default Original Language settingSelect a setting using Cursor Subtitle Default OFFDisplay setting Language setting cont’dAngle Icon Default on Screen Saver Default 10 minutes Display setting cont’dAudio setting FL Dimmer Default BrightAudio setting cont’d Select a setting using Cursor K / L, then press EnterVideo setting Dynamic Range Control Default onVideo Out Default Scartrgb Video setting cont’dTV System Default PAL Set the TV system Select Yes using CursorProceed with either of the following steps Select Parental Lock using Cursor K / L, then press EnterDVD-Videos Parental Lock level AllDVD-Videos Parental Lock level cont’d Your setting is activated If you select No, proceed to stepChange the password YesPlayback Select the recording mode using REC MODE. See Recording and One-touch Timer Recording OTR cont’dOne-touch Timer Recording Turn on the unit and insert a recordable tapeIndex search Other operations Selecting the Sound ModeMode Audio output Display on Hi-Fi Stereo Sound SystemVCR / DVD TroubleshootingSET DVD 92 ENProcess is cancelled, the disc MAY not work VCRTroubleshooting cont’d Error message Cause SolutionLanguage code Language CodeDTS GlossaryCprm JpegAudio recording format SpecificationsVideo recording format Receivable channelsPage 1300 135 Congratulations on Your Purchase 1VMN23152
Top Page Image Contents