MOUNTING PRECAUTIONS
•This product is for use indoors.
•Consult your dealer before installing, removing or moving the monitor.
•A mounting bracket compliant with VESA specifications is required. Do not use any screw holes other than VESA holes for installation.
•When moving the monitor, do not place your hand on the screen. This may cause product damage, failure, or injury.
•Install the monitor with the surface perpendicular to a level surface. If you tilt the monitor, do not tilt more than 20° up or down.
•Mounting the monitor on the wall requires special expertise and the work must be performed by an authorized SHARP dealer. You should never attempt to perform any of this work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or mishandling.
•This monitor should be used at an ambient temperature between 32°F (0°C) and 104°F (40°C). Provide enough space around the monitor to prevent heat from accumulating inside.
For the monitor in horizontal orientation
| Unit: inch [cm] |
2 | 2 |
[5] | [5] |
2 [5] |
|
For the monitor in vertical orientation
•After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
•Do not place the monitor on a device which generates heat.
•Use the supplied vertical sticker when you install the monitor in vertical orientation.
Operation panel
Logo
-Be careful not to cover the remote control sensor or buttons.
•Be sure to use a
•This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials such as plaster / thin plastic board / wood before starting installation.
This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor. Install by the most suitable method for the material and the structure.
| |
2 | 2 |
[5] | [5] |
| 2 [5] |
Unit: inch [cm]
•If it is difficult to provide sufficient space for any reason such as the installation of the monitor inside a housing, or if the ambient temperature may be outside of the range of 32°F (0°C) to 104°F (40°C), install a fan or take other measures to keep the ambient temperature within the required range.
•Temperature condition may change when using the display together with the optional equipments recommended by SHARP. In such cases, please check the temperature condition specified by the optional equipments.
•Adhere to the following when installing the monitor in its vertical orientation. Failing to adhere to the following may cause malfunctions.
-Install the monitor such that the power LED is located on the bottom side.
-Mount so that the mark on the back points up.
-Set the THERMAL SENSOR SETTING in the SETUP menu to PORTRAIT. (See page 19.)
•Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a malfunction.
5E