QUICK REFERENCE
■
1Confirm that there are 12 screws (8 long screws and 4 short screws) supplied with the stand unit.
21 Set the post for the stand unit onto the polystyrene foam.
2Attach the base to the post.
3Insert and tighten the 8 screws into the 8 holes on the bottom of the base.
•Hold the stand unit securely with one hand, and then tighten the screws.
■LC-70LE657U/LC-70LE655U/LC-70LE650U/ LC-70C6500U
Long screws
3
2
1
31 Insert the stand into the openings on the bottom of the TV.
•Make sure that the stand is fi rmly inserted into the TV. Improper installation may result in tilting of the TV set.
2Insert and tighten the 4 screws into the 4 holes on the rear of the TV.
Soft cushion
2 Short screws
2
1
1
Attaching the Stand (for the 90/80 Inch Models)
Building the Work Table
Before attaching the stand to the TV, build a work | 2 The case is equipped with |
table on which to rest the TV. | hold the cushioning materials in place. Push |
• To build the table, use the cushioning materials | in the tabs (2 for each location) to secure the |
used in the packaging. | cushioning materials in the case. |
• Of the cushioning materials used, | ||
used during stand unit assembly. Be sure to | ||
| ||
assemble the stand unit before building the work |
| |
table. |
| |
| ||
| ||
|
■LC-90LE657U
1
FRONT
■LC-60LE657U/LC-60LE655U/LC-60LE650U/ LC-60C6500U
Long screws
3
1Insert each of the cushioning materials in the respective directions shown in the fi gure.
•Insert
•Insert
CASE
LINE
JOINT
2
1
CASE | |
|
LINE
Attach the joints and close the case.
1Insert a joint into the hole on the side of the case.
2Pressing the tab, fi x the joint into place.
1
FRONT
1
2
3After you have built the work table, spread a blanket or similar soft cloth over the table and then lay the TV display down on the covered table before attaching the stand to the TV.
•Do not use a small table for this.
•Refer to the operation manual for information on attaching the stand.
•In the installation procedure, be careful not to catch your fi ngers between the TV set and the fl oor.
•Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
•After attaching the stand to the TV, do not hold the stand when you put up, set up, move or lay down the TV.
7