Sharp LC-40LE832U Preparation, Antennas, Installing Batteries in the Remote Control Unit

Page 12

Preparation

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. For connecting the antenna cable to the TV, use commercially available cables.

Connecting Antenna Cable

Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4).

 

 

Home Antenna

1 Cable without a CATV

Cable TV lead-In

terminal (75-ohm)

 

converter

 

Coaxial cable

 

 

2 VHF/UHF antenna

75-ohm coaxial cable (round)

Home Antenna terminal (75-ohm)

3 Combination VHF/

UHF antenna

4 Separate VHF/UHF

antenna

 

 

 

 

Coaxial cable

 

75-ohm coaxial cable (round)

 

 

 

 

or

 

 

 

300-ohm twin-lead cable (flat)

300/75-ohm adapter

 

 

 

VHF

UHF

300-ohm

 

 

ANTENNA

ANTENNA

 

 

twin-lead cable

 

 

 

 

 

 

 

 

 

IN

OUT

 

300-ohm twin-lead cable

Combiner

 

 

 

 

or 75-ohm coaxial cable

 

 

To TV antenna terminal

1.A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools.

2.A 300-ohm system is a fl at “twin-lead” cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter.

F-type connector

75-ohm coaxial cable (round)

300-ohm twin-lead cable (fl at)

NOTICE F-type connector should be finger-tightened only.

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

F-type connector

75-ohm coaxial cable

Installing Batteries in the Remote Control Unit

If the remote control fails to operate TV functions, replace the batteries in the remote control unit.

1Open the battery cover.

2 Insert two “AAA” size batteries (supplied with 3 Close the battery cover. the product).

• Place the batteries with their terminals corresponding to the (e) and (f) indications in the battery compartment.

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.

Do not mix batteries of different types. Different types of batteries have different characteristics.

Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a rash. If you fi nd any chemical leakage, wipe thoroughly with a cloth.

The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

If you will not be using the remote control unit for an extended period of time, remove batteries from it.

10

Image 12
Contents LC-40LE832U LC-46LE832U LC-52LE832U LC-60LE832U Page Model No To aid reporting in case of loss or theft, please recordFCC Compliance Statement Industry Canada StatementAdditional Safety Information Dear Sharp CustomerPrecautions when transporting the TV Caring for the cabinetChild Safety Caring for the front panelContents Supplied Accessories Attaching the StandLC-40LE832U Insert the stand into the openings on the rear of the TVLC-46LE832U/LC-52LE832U LC-60LE832UBase facing forward Stand into the openings on the rearUsing the Remote Control Unit Insert the batteries into the remote control unit. SeeRemote control sensor AC outletInstalling Batteries in the Remote Control Unit Connecting Antenna CablePreparation AntennasPart Names TV FrontTV Rear Remote Control Unit Part NamesIntroduction to Connections Experiencing HD ImagesTypes of Connection Displaying an External Equipment ImageConnecting to External Equipment When using Hdmi cable Hdmi 1, 2, 3 orWhen using DVI-HDMI conversion cable Hdmi Back panel vertical inputsConnecting to External Equipment When using Component cable ComponentWhen using Composite cable Video 1 or Back panel surface inputsConnecting an Audio Amplifier Connecting an AV AmplifierConnecting a PC When using analog RGB cable PC Back panelBack panel horizontal inputs Back panel vertical inputs Surface inputsTurning On/Off the Power Initial Installation Language Language settingWatching TV TV LocationAir/Cable Antenna setting Watching TV Antenna & Cable/STBCH Search Channel search To watch TV via a set-top boxExamples of the settings confirmation screen Watching TV CompletedChanging Volume Sleep TimerDirect Button Operation Changing ChannelsPress Power Saving Example When the input source is TV, COMPONENT, Video 1 orDirect Button Operation Press InputClosed Captions and Digital Closed Captions Press CCExamples This will present the Closed Caption information displayPress View Mode You can select the screen sizeFor HD programs For 43 programsUsing the remote control On-Screen Display MenuOn-Screen Display Menu Operation Menu Operation ButtonsMenu Items On-Screen Display MenuPicture Settings AV Mode Changing Pic.QualityOPC Setting Advanced Picture SettingsColor Temp Color Temperature Gamma AdjustmentFilm Mode 32 pull-down Color Gamut RangeAudio Settings Auto VolumeSurround Bass EnhancerPower Control Power SavingNo Signal Off Audio OnlySystem Options View OptionInput Terminal Setting Menu DesignIcon Light Up Setting Demo ModeCaption Setup Game Play TimeInitial Setup EZ SetupBroadcasting Setup CH SetupReset Wall Mount Audio SetupIndividual Setup LanguageWhen setting an individual content-based rating item ChipChip is an electronic fi ltering device built into your TV Parental GuidelinesHow to temporarily release the V-CHIP Block Canadian English RatingsCanadian French Ratings Reactivating the temporarily released V-CHIP BlockSoftware Update InformationIdentification Digital Caption Info Digital Caption InformationUpdating the Software via the Network Call 1-800-BE-SHARPPress Enter to start checking the data in the USB Memory device Select Yes, and then press EnterDuring the data checking, Checking blinks After the screen shown below is displayed, pressConnecting a USB Memory Device/USB Hard Drive Connecting a Home Network Dlna ServerEnjoying Photo/Music/Video Playback Ethernet cable Home network Dlna serverWhen displaying the data with the Apps Select the Files to Play BackEnjoying Photo/Music/Video Playback USB memory devicePhoto Mode Playing Back Files on a USB Memory DeviceUSB Menu Select Slide Show IntervalSelect Slide Show BGM Buttons for slide show BGM select operationMusic Mode Video ModeButtons for playing mode Buttons for music mode Set/Reset All Auto PlayUsing the operation panel Menu for playing modeUSB Menu Menu for file selecting operations Title/ChapterDivX Setup Press a/b to select DivX Setup, and then press EnterUSB Device Compatibility DivX VOD registration DivX VOD deregistrationPlaying Back Files on a Home Network Dlna Server Home Network Dlna MenuButtons Description C/d Yellow Display the Home Network Dlna Menu ScreenButtons for playing mode Home Network Dlna Server CompatibilityPresetting Remote Control Function Presetting manufacturer codesOther Viewing Options Operating the Connected EquipmentOther Viewing Options Manufacturer codes Using Aquos Link Controlling Hdmi Equipment Using Aquos LinkUsing Aquos Link Aquos Link SetupOne Touch Playback Link Operation Menu One Touch RecordingStart/Stop Recording Displaying the Link Operation MenuUsing the Device Operation Panel Timer RecordingPlayback of Titles Using Aquos Link Manually Changing Aquos Audio Speaker System’s Sound ModeUsing a PC Displaying a PC Image on the ScreenStretch Dot by Dot Adjusting the PC Image Setting Audio InputPC Compatibility Chart Using a PCControl of the TV Using a PC Command table Commands not indicated here are not guaranteed to operateUsing the Internet Connecting to the InternetUsing an Ethernet cable About the original homeUsing the Internet Using the wireless LANInternet Setup Interactive ServiceWireless Setup Checking Your Internet ConnectionDisplaying Updated Information and Support Service Original HomeAquos Advantage Live Entering Text Software Keyboard Using the Browser Featured ContentAbout links Using the Toolbar Using Tabs Selected itemSelected item Description Select This Close This TabSaving the URL of the Current Opening a BookmarkedEditing Bookmarks Browser Settings Security SettingsView Settings Using Applications via the Internet Deactivating Netflix FunctionDeactivating the Vudu Function Disclaimers Appendix Removing the StandBefore detaching or attaching the stand, unplug the AC cord LC-60LE832U Before attaching/detaching the standSetting the TV on the Wall Optional AccessoriesAppendix Hanging on the wallTroubleshooting Pages 24Pages 27 Troubleshooting Error Message Error code Possible Solution Displayed on a screenE202 E203Initial Setup menu Software Update Information menuCH Setup Broadcasting Setup TrademarksSpecifications Model LC-40LE832U Model LC-46LE832USpecifications Model LC-52LE832U Model LC-60LE832UWireless LAN SpecificationInformation on the Software License for This Product Software compositionSoftware developed by Sharp and open source software Obtaining source codeInformation on the Software License for This Product Software CopyrightsCalling for Service Limited WarrantyDimensional Drawings AN-37AG2 AN-37P30AN-52AG4 LC-52LE832U Sharp Electronics Corporation