Useful adjustment settings
Input Skip
This setting allows you to skip the HDMI or DVI input on the Input Selection operation.
1 Press MENU and the MENU screen displays.
2 Press c/dto select “Setup”.
3 Press a/bto select “Input Skip”, and then press ENTER.
4 | Press a/b to select the Input | (INPUT4, |
| INPUT5 or INPUT6) you wish to | skip, and |
then press ENTER.
INPUT 4 (HDMI1)
INPUT 5 (HDMI2)
INPUT 6 (DVI)
Yes | No |
5 | Press c/dto select “Yes”, and then press |
| ENTER. |
6 | Press MENU to exit. |
Input Signal (PC input mode only)
•Some input signals may have to be registered manually to display properly.
•The pairs of input signals (resolutions) in the list below are not distinguishable when received. In such case, you have to set the correct signal manually. After setting once, it will display when the same signal (resolution) is input again.
1024g7681360g768
NOTE
•You can only select the “Input Signal” on the Setup menu when receiving one of the 2 input signals listed above.
1 Press MENU and the MENU screen displays.
2 Press c/dto select “Setup”.
3 Press a/bto select “Input Signal” and then press ENTER.
4 Press a/bto select the desired input signal on the display.
1024 x 768
1360 x 768
(Example)
34