Quick guide
Turning on the power
Press aon the TV.
Standby mode
Press Bon the remote control unit when the TV is on.
•The TV enters standby mode and the image on the screen disappears.
•The Bindicator on the TV changes from green to red.
•To completely turn off the power to the TV, unplug the AC cord from the AC outlet. However, do not unplug the AC cord unless otherwise instructed.
Display status indicator
Off | Power off |
|
|
Red | The TV is in standby mode. |
Green | The TV is on. |
|
|
NOTE
•If you are not going to use this TV for a long period of time, be sure to remove the AC cord from the power outlet.
•Weak electric power is still consumed even when ais turned off.
•In DTV input mode, if the power is turned off immediately after a setting change from the menu screen, the new setting or channel information may not be memorised.
Initial auto installation (Analogue)
When the TV powers on for the fi rst time after purchase, the initial auto installation (Analogue) is invoked. Follow the menus and make the necessary settings one after another.
NOTE
•To reconfi gure the initial auto installation settings, go to “Channels” and run “Search wizard” from the Setup menu. (Page 19)
1Setting the on-screen display language
1Press a/b/c/d to select the desired language listed on the screen.
2Press OK to enter the setting.
2Setting the country (“Location of TV set” screen)
1Press a/b/c/d to select your country or area listed on the screen.
2Press OK to enter the setting.
•An overview of settings to be used for auto search displays.
3Press OK to start the search.
•The TV searches for, sorts and stores all the receivable TV stations according to their settings and the connected antenna.
•To abort the initial auto installation in progress, press END.
4When the auto sorting is completed, the item “Decoder” displays. Press c/d to select “EXT 1” or “EXT 2”, and then press OK.
•Make sure to select the terminal (EXT 1 or 2) to which the decoder is connected.
5A message appears indicating that the first installation is successfully completed. Press OK, if necessary.
•If a recording device with
Initial auto installation (DTV)
Digital Video Broadcasting is a transmission scheme. It is much more than a simple replacement for existing analogue television transmission. DVB provides more stations, clearer picture quality and other services displayed on the screen. It also allows a range of new features and services including subtitles and multiple audio tracks.
To watch DTV broadcasts, follow the procedures below to scan all available services in your area.
NOTE
•Make sure to perform Initial auto installation (Analogue) outlined in the preceding section as well, even if you intend to view only DTV broadcasts.
1Press DTV (or b, then a/b to select “DTV”, and then press OK) to access the DTV mode.
2Press DTV MENU and the DTV Menu screen displays.
3Press c/d to select “Installation”.
4Press a/b to select “Auto Installation”, and then press OK.
If you have already set the PIN, enter it here. If not, enter the factory preset PIN “1234”.
•See page 20 for setting PIN.
•A confi rmation message displays. Press c/d to select “Yes”, and then press OK to start the search.
5The TV starts scanning all available DTV and radio services in your area.
NOTE
•The language and country settings used in this operation are the settings you have already set while executing the Initial auto installation (Analogue). If you want to reconfi gure the country setting, for instance after moving to another country, conduct “Search wizard” from the Analogue Menu again. (Page 19)
•The DTV services are searched and stored according to the channel number information embedded in the TV signal (if available). If the information is not available, the services are stored according to the order in which they were received. If you would like to sort the order, it is possible to arrange it as explained in page 28.
•To cancel the scan in progress, press END.
•You cannot select any
8