Sharp LC-46XL1S, LC-46XL1E, LC-52XL1E Supplied accessories, Quick guide, Attaching the stand

Supplied accessories

	AC cord (g1)		Cable tie (g1)	Stand unit		Cable clamp	3 RCA to 15-pin
(For Europe, except		(For U.K. and Eire)			(g1)	(Smallg2, Large g1)	D-sub adapter
								(g1)
U.K. and Eire)

U.K. type 3-pin AC cord is only included

with models LC-46XL1E,

LC-52XL1E.

Page 4 Page 4 Page 3 Page 4 Page 10

•“AAA” size battery (g2)..........Page 6 • Remote control unit (g1)..........Pages 6 and 7

•Operation manual (This publication)

Quick guide

Attaching the stand

Before performing work spread cushioning over the base area to lay the TV on, making sure the area is completely flat. This will prevent it from being damaged.

Before attaching (or detaching) stand, unplug the AC cord from the AC INPUT terminal.

CAUTION

•Attach the stand in the correct direction.

•Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.

1Confirm that there are 10 screws (6 short screws and 4 long screws) supplied with the TV.

2Attach the two supporting posts for the stand unit onto the base using the box for the stand unit as shown below.

(Close-up of the upper side of the stand unit)

Hex key

31Insert the stand into the openings on the bottom of the TV.

2Insert and tighten the 4 long screws into the 4 holes on the rear of the TV.

Hex key

Long screw

Soft cushion

Short screw

1Insert each of the protrusions on the two supporting posts into the openings on the upper side of the base.

2Insert and tighten the 6 short screws with the hex key (supplied with the product) in the order of 1, 2 and 3.

NOTE

•To detach the stand, perform the above steps in reverse order.

3