Sharp LC-52LE925UN Preparation, Antennas, Installing Batteries in the Remote Control Unit

Page 12

Preparation

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. For connecting the antenna cable to the TV, use commercially available cables.

Connecting Antenna Cable

Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4).

 

 

Home Antenna

1 Cable without a CATV

Cable TV lead-In

terminal (75-ohm)

 

converter

 

Coaxial cable

 

 

2 VHF/UHF antenna

75-ohm coaxial cable (round)

Home Antenna terminal (75-ohm)

3 Combination VHF/

UHF antenna

4 Separate VHF/UHF

antenna

 

 

 

 

Coaxial cable

 

75-ohm coaxial cable (round)

 

 

 

 

or

 

 

 

300-ohm twin-lead cable (flat)

300/75-ohm adapter

 

 

 

VHF

UHF

300-ohm

 

 

ANTENNA

ANTENNA

 

 

twin-lead cable

 

 

 

 

 

 

 

 

 

IN

OUT

 

300-ohm twin-lead cable

Combiner

 

 

 

 

or 75-ohm coaxial cable

 

 

To TV antenna terminal

1.A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools.

2.A 300-ohm system is a fl at “twin-lead” cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter.

F-type connector

75-ohm coaxial cable (round)

300-ohm twin-lead cable (fl at)

NOTICE F-type connector should be finger-tightened only.

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

F-type connector

75-ohm coaxial cable

Installing Batteries in the Remote Control Unit

If the remote control fails to operate TV functions, replace the batteries in the remote control unit.

1Open the battery cover.

2 Insert two “AAA” size batteries (supplied with 3 Close the battery cover. the product).

• Place the batteries with their terminals corresponding to the (e) and (f) indications in the battery compartment.

CAUTION

Improper use of batteries can result in chemical leakage or explosion. Be sure to follow the instructions below.

Do not mix batteries of different types. Different types of batteries have different characteristics.

Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries or cause chemical leakage in old batteries.

Remove batteries as soon as they are worn out. Chemicals that leak from batteries that come in contact with skin can cause a rash. If you fi nd any chemical leakage, wipe thoroughly with a cloth.

The batteries supplied with this product may have a shorter life expectancy due to storage conditions.

If you will not be using the remote control unit for an extended period of time, remove batteries from it.

10

Image 12
Contents LC-52LE925UN LC-60LE925UN Page Model No To aid reporting in case of loss or theft, please recordFCC Compliance Statement Industry Canada StatementAdditional Safety Information Dear Sharp CustomerPrecautions when transporting the TV Caring for the cabinetChild Safety Caring for the front panel3D Glasses Contents Supplied Accessories Attaching the StandInsert the stand into the openings on the rear Connection guide g1Using the Remote Control Unit Insert the batteries into the remote control unit. SeeRemote control sensor Bundle the cords properly with the cable clampInstalling Batteries in the Remote Control Unit Connecting Antenna CablePreparation AntennasPart Names TV FrontTV Rear Remote Control Unit Part NamesIntroduction to Connections Experiencing HD ImagesTypes of Connection Displaying an External Equipment ImageConnecting to External Equipment When using Hdmi cable Hdmi 1, 2, 3 orWhen using DVI-HDMI conversion cable Hdmi Back panel vertical inputsConnecting to External Equipment When using Component cable ComponentWhen using Composite cable Video Back panel horizontal inputsConnecting an Audio Amplifier Connecting an AV AmplifierConnecting a PC When using analog RGB cable PC Back panel vertical inputsTurning On/Off the Power Initial Installation Language Language settingWatching TV TV LocationAir/Cable Antenna setting Examples of the settings confirmation screenWatching TV Antenna & Cable/STB CompletedChanging Volume Sleep TimerDirect Button Operation Changing ChannelsPress Power Saving Example When the input source is TV, Component orExample When the input source is PC in or Hdmi 1 to Direct Button OperationClosed Captions and Digital Closed Captions Press CCExamples This will present the Closed Caption information displayPress View Mode You can select the screen sizeFor HD programs For 43 programsUsing the remote control On-Screen Display MenuOn-Screen Display Menu Operation Menu Operation ButtonsMenu Items On-Screen Display MenuPicture Settings AV Mode Changing Pic.QualityOPC Setting Advanced Picture SettingsColor Temp Color Temperature Gamma AdjustmentFilm Mode 32 pull-down Motion EnhancementAudio Settings Auto Volume3D Surround Bass EnhancerPower Control Power SavingNo Signal Off Audio OnlySystem Options View OptionInput Terminal Setting Menu DesignIcon Light Up Setting Demo ModeCaption Setup Game Play TimeInitial Setup EZ SetupBroadcasting Setup CH SetupIndividual Setup Wall Mount Audio SetupReset LanguageWhen setting an individual content-based rating item ChipChip is an electronic fi ltering device built into your TV Parental GuidelinesHow to temporarily release the V-CHIP Block Canadian English RatingsCanadian French Ratings Reactivating the temporarily released V-CHIP BlockSoftware Update InformationIdentification Digital Caption Info Digital Caption InformationUpdating the Software via the Network Call 1-800-BE-SHARPPress Enter to start updating During the data checking, Checking blinksAfter the screen shown below is displayed, press Remove the USB memory deviceEnjoying 3D Image Viewing Display Methods for 3D and 2D ImagesSupplied Accessories for 3D Glasses 3D GlassesEnjoying 3D Image Viewing Part NamesAttaching the Nose Pad Before Using the 3D Glasses Replacing the BatteryAttaching the 3D Glasses Band Using the 3D Glasses Viewing 3D ImagesUsage Range of the 3D Glasses Switching to the Previous Mode Switching from 3D to 2D ModeWatching 2D Images in 3D 3D MenuConfiguring the TV Settings to Enhance 3D Image Viewing 3D Setup3D Brightness Boost Specifications 3D Glasses 3D Glasses lenses3D Glasses infrared receiver When displaying the data with the Input list screen When displaying the data with the AppsEnjoying Photo/Music/Video Playback Viewing Photos, Listening to Music and Watching VideosPhoto Mode Viewing ThumbnailsViewing Individual Photos Slide ShowSet/Reset All Slide Show Image Select Slide Show IntervalSelect Slide Show BGM Buttons for slide show BGM select operationMusic Mode Video ModeDivX Setup Using the control panelUSB Memory Device Compatibility DivX VOD registration DivX VOD deregistrationPresetting Remote Control Function Presetting manufacturer codesOther Viewing Options Operating the Connected EquipmentOther Viewing Options Manufacturer codes Using Aquos Link Controlling Hdmi Equipment Using Aquos LinkUsing Aquos Link Aquos Link SetupOne Touch Playback Link Operation Menu One Touch RecordingStart/Stop Recording Turning On/Off Aquos LINK-compatible EquipmentUsing the Device Operation Panel Timer RecordingPlayback of Titles Using Aquos Link Manually Changing Aquos Audio Speaker System’s Sound ModeUsing a PC Displaying a PC Image on the ScreenStretch Dot by Dot Adjusting the PC Image Setting Audio InputPC Compatibility Chart Using a PCPC Control of the TV Using a PC Command table Commands not indicated here are not guaranteed to operateUsing the Internet Connecting to the InternetUsing an Ethernet cable About the original homeUsing the Internet Using the wireless LAN USB adapterInternet Setup Interactive ServiceWireless Setup Checking Your Internet ConnectionDisplaying Updated Information and Support Service Setting the CountrySetting the Zip Code Sidebar WidgetEntering Text Software Keyboard Using the Browser Featured ContentAbout links Using the Toolbar Using Tabs Selected itemSelected item Description Select This Close This TabSaving the URL of the Current Opening a BookmarkedEditing Bookmarks Browser Settings Security SettingsView Settings Settings for Watching Netflix Content on the TV Instantly Watching Movies from NetflixHIf you do not have a Netflix account If you have a Netflix accountAdding Content to the Instant Queue Deactivating Netflix FunctionHThe buttons that can be used during playback Vudu Movies features Enjoying Movies and Internet Applications with VuduGetting Started Watching a Movie on VuduTroubleshooting Vudu Deactivating the Vudu FunctionOperational buttons during playback Disclaimers Appendix Removing the StandBefore detaching or attaching the stand, unplug the AC cord LC-52LE925UN Before attaching/detaching the standSetting the TV on the Wall Optional AccessoriesUsing an optional bracket to mount the TV AppendixTroubleshooting Pages 23Pages 26 Troubleshooting 3D Images Troubleshooting Error MessageInitial Setup menu Software Update Information menuCH Setup Broadcasting Setup TrademarksSpecifications Model LC-52LE925UN Model LC-60LE925UNWireless LAN USB Adapter SpecificationsSpecification Information on the Software License for This Product Calling for Service Limited WarrantyPage Page Dimensional Drawings 15/64 AN-52AG455/64 AN-52AG4 Sharp Electronics Corporation