Enjoying 3D Image Viewing
Attaching the Nose Pad | Before Using the 3D Glasses |
Attach either of the supplied nose pads as needed (such as when the glasses do not fi t properly). The glasses come with a large and small nose pad.
Attaching the nose pad
Removing the nose pad
Before using the 3D Glasses for the fi rst time, remove the insulating sheet attached to them.
Replacing the Battery
The battery has an expected service life of approximately 75 hours.
•When the battery power is low, the LED light blinks 6 times after the power is turned on.
•When replacing the button cell, use only the designated battery (Hitachi Maxell: CR2032 lithium button cell).
1 
1
1 Loosen the screw used to secure the battery cover. 2 Remove the battery cover.
2
Attaching the 3D Glasses Band
Attach the supplied 3D Glasses band strap as needed (such as when the glasses do not fi t properly).
Insert the ends of the 3D Glasses into the 3D Glasses band until they are secure.
•Pull the cord stopper on the strap to adjust the strap length.
3 Place the tip of the slotted precision screwdriver into the opening between the battery and the socket.
4 Lift up the battery while taking care not to get the screwdriver caught on the metal latch.
5 When the battery comes loose from the socket, pick it out with your fi ngers.
6 Hook a new battery to the metal latch and insert it into the socket.
7 Close the battery cover.
8 Insert the screw to secure the battery cover.
1 |
|
|
| 2 | 4 |
| 3 | |
5 | 6 |
|
8
7
•Take care not to reverse the battery poles (+ and
•Used batteries should be disposed of strictly in accordance with the applicable local laws and regulations.
42