Basic adjustment settings (Analogue/Digital)
Monochrome
For viewing images in monochrome.
1Press MENU and the MENU screen displays.
2Press c/d to select “Picture”.
3Press a/b to select “Advanced”, and then press ENTER.
4Press a/b to select “Monochrome”, and then press ENTER.
5Press c/d to select “On”, and then press
ENTER.
Film Mode
Automatically detects a fi
1Repeat steps 1 to 3 in Monochrome.
2Press a/b to select “Film Mode”, and then press ENTER.
3Press c/d to select “On”, and then press
ENTER.
NOTE
Range of OPC
The brightness level range of the OPC sensor’s automatic adjustments can be set according to your preferences. The adjustment range of the OPC sensor can be set to a maximum of +16 and a minimum of
1Repeat steps 1 to 3 in Monochrome.
2Press a/b to select “Range of OPC”, and then press ENTER.
3Press a/b to select “Max.” or “Min.”, and then adjust the item to the desired position.
Selected item | Description |
|
|
Max. | |
|
|
Min. | |
|
|
NOTE
•This function is available only when the OPC setting is set to On.
•The maximum setting cannot be set to a smaller number than the minimum setting.
•The minimum setting cannot be set to a bigger number than the maximum setting.
•The maximum and minimum settings cannot be set to the same number.
•Depending on the brightness of the surrounding light, the OPC sensor might not operate if the adjustment range is small.
•Film Mode is not selectable depending on the input signal type.
29