Preparation
Attaching the stand unit – 52/46/40LE835X
4Insert and tighten middle screws into the holes on the rear of the TV.
•Before performing work, spread cushioning over the surface on which you will be laying the TV. This will prevent it from being damaged.
CAUTION
•Attach the stand in the correct direction.
•Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
1Confirm that there are screws with the stand unit.
For 52/46 inch models
(four long screws, four middle screws and one short screw)
For 40 inch models
(three long screws, three middle screws and one short screw)
2Attach the supporting post for the stand unit onto the base using the long screws with a screwdriver as shown.
Long screws
Middle 
screws
Middle screws
40 inch models
52/46 inch models
5 Attaching | stand cover. | |
1 | Insert | cover. |
2 | Insert | a short screw into the hole of the |
| stand |
|
|
| Short |
|
| screw |
Supporting post
40 inch models
Long screws
NOTE
• To detach the stand unit, perform the steps in reverse order.
• A screwdriver is not supplied with this product.
52/46 inch models
3Insert the stand into the openings on the bottom of the TV (hold the stand so it will not drop from the edge of the base area).
Soft cushion
40 inch models | 52/46 inch models |
7