Sharp LC-32DA5U, LC-26DA5U manual 11101011, Appendix PC Control of the TV, Parameter

Appendix

PC Control of the TV

,,When a program is set, the TV can be controlled from the PC using the RS-232C terminal. The input signal (PC/AV) can be selected, the volume can be adjusted and various other adjustments and settings can be made, enabling automatic programmed playing.

®Attach an RS-232C cable cross-type (commercially available) to the supplied Din/D-Sub RS-232C for the connections.

®This operation system should be used by a person who is accustomed to using computers.

Communication conditions

Set the RS-232C communications settings on the PC to match the TV'scommunications conditions. The TV'scommunications settings are as follows:

Communication procedure

Send the control commands from the PC via the RS-232C connector.

The TV operates according to the received command and sends a response message to the PC.

Do not send multiple commands at the same time. Wait until the PC receives the OK response before sending the next command.

Command format

Eight ASCII codes + CR

IC1 !C2 !C3 !C4 IPl!P2 !P3 !P4 I__1 I OommanParameter4-digits: Parameter0_4-dlglts:OommandThe-9, x, blank,?

Command 4-digits Parametel 4-digits Return code

Parameter

Input the parameter values, aligning left, and fill with blank(s) for the remainder. (Be sure that 4 values are input for the parameter.)

When the input parameter is not within an adjustable range, "ERR" returns. (Refer to "Response code format".) Any numerical value can replace the "x" on the table.

Io! ! I I 101010191 1131011

11101011

Io!o!_1_1

When "?" is input for some commands, the present setting value responds.

Q "47