Sharp LE824, LE914, LE925, LE822, LE814, LE820 manual Control

Page 6

Choose „Yes“ and confirm your choice with the „OK “ button on the remote

control.

Now you will see the following:

Confirm the displayed setting by pressing the „OK “-button on the remote control. (An explanation of this setting can be found in the chapter „Frequently asked questions" in the appendix). The example shows the installation for a satellite device with an individual connection (only Astra). After confirmation you will see the following image:

If you use a satellite device with an "exotic" LNB, here you can set the oscillator frequencies of upper and lower sidebands. For a normal, standard LNB confirm the displayed settings by pressing the „OK “-button on the remote control.

The following happens then:

Page - 6 -

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Instructions for Installation of Satellite Channels When the device has already been fully installed Remedy First installation Page Page Control Page Page Page Page Sort channels manually Page Page Page Page Page Receive signal from special satellites Page „Menu Setup Settings Channel settings Antenna setup digital Special case attenuator7777 3535 Frequently asked questions Toneburst switchbox switch for two satellites 22kHz Switchbox Switch for two satellitesHighband 22kHz signal Definition of terms concerning satellite receptionRepetition rate in DiSEqC operation MultiswitchCommunity installation single cable system Astra 1 / Astra 2 / AstraLNB Intermediate frequency Symbol rateLNB low-noise block converter Transponder
Related manuals
Manual 13 pages 5.6 Kb
Top Page Image Contents