Sharp IG-CH2J Remove the filter, Clean up the filter, Set the filter on the main unit

Page 11

FILTER

If the FILTER CLEAN light is (orange)

Even if the FILTER CLEAN light (orange) does not light, it is recommended to carry out the cleaning once a week.

Remove the filter.

 

2

 

1

1 The filter is attached to the rear of

 

 

 

the main unit.

 

1

Clip the tabs on both sides of the

Tabs

 

filter and pull it out.

 

 

Clean up the filter.

 

 

2 Gently remove the dust attached to the

 

filter with a vacuum cleaner.

 

 

Do not press the filter with force with a

Filter

vacuum cleaner. Otherwise, it is damaged.

<For Stubborn Dirt>

Remove and rinse in water. (Use a soft sponge if the dirt does not come off easily.) And dry it at the sun shadow place.

3 Set the filter on the main unit.

Insert the filter until the stopper of tab is inserted into the main unit firmly.

Filter

Stopper

ENGLISH

Do not operate the product while the filter is removed. The dust comes in the main unit and it may cause a failure.

4 Press the ON/OFF button for 3 seconds.

The FILTER CLEAN light flashes twice and go off. Even if the FILTER CLEAN light is off, press ON�OFF button for 3 seconds after cleaning.

E-9

ON/OFF button

Image 11
Contents IG-CH2J Page English Important Safety Instructions Installation Guidelines Parts Name Back Connection of AC adapter and installation of main unit Installation GuidePress the ON/OFF button to turn off OperationPress the ON/OFF button to turn on Wipe off the taint with a soft cloth Cleaning and MaintenanceRemove the dust with a vacuum cleaner Press the ON/OFF button for 3 seconds Clean up the filterRemove the filter Set the filter on the main unitGenerating Unit Remove the cleaning brushClean up the needle electrode of the Plasmacluster Ion Remove the louverPin Specifications What to do TroubleshootingPage English Memo English Sharp Corporation of NEW Zealand Limited