Sears 274.4394859 owner manual Using Advanced Features, Placing Channels in Memory Autoprogramming

Using Advanced Features

Placing Channels in Memory (Autoprogramming)

Only channels 2-13 appear in the TV's memory when you first turn it on.

The channels available in your area must be programmed into the TV's memory when you hook up your TV. Using CHANNEL up and down allows you to scan through these channels.

You may want to add or delete a few channels if some stations have weak

signals or were off the air when the TV was programmed. Refer to the Add or Delete Channels section below.

lo Place channels in	13!
memory (Autoprogram)
;ontrols	Alarm Ad

3ntrols Alarm Adjust Setup

A. Hook up an antenna, cable or components before you begin

these steps or you will not be able to add channels into

memory.

B. Press MENU.PROG repeatedly

to select the Setup Menu. This menu is white.

C. Press MOVE • to highlight Autoprogram.

D. Press MOVE • to start the TV adding all active channels into memory.

E. Wait until the TV has cycled through all the channels and returns to the original channel.

2. Add or delete channels

Controls Alarm Ad

Controls Alarm Ad

a. Press MENU,PROG repeatedly

to select the Setup menu. This menu is white.

B. Press MOVE • to highlight Channel Memory.

C. Press MOVE • to underline the channel number.

D.Select the channel number you want to add or delete with the number buttons.

E.Press MOVE • to add or delete

a channel (you will see Stored on the screen when added and

Erased when deleted).

F° Repeat D and E for more channels.

2O