Sony SLV-SE450B VCR below Reglage Auto Press Regl Canal, To obtain a clear picture from the VCR

5		CHAINE
	ALIGNEMENT

Press CHAINE +/– (repeatedly) to select the appropriate TV system for your area.

Select “L” for the L TV system (SECAM), or “G” for the B/G TV system (PAL).

6	Tune the TV to the same channel shown in
	the VCR display window so that the
	picture on the right appears clearly on the	MAGNETOSCOPE SONY
	TV screen.
	Refer to your TV manual for TV tuning
	instructions.
	If you select the wrong TV system in step
	5, the picture on the right may not appear.
	Select the appropriate TV system and tune
	the TV again.
	If the picture does not appear clearly, see “To obtain a clear picture from the
	VCR” below.
7	REGLAGE AUTO Press REGL CANAL.
	REGL CANAL

You have now tuned your TV to the VCR. Whenever you want to play a tape, set the TV to the video channel.

To check to see if the TV tuning is correct

Set the TV to the video channel and press CHAINE +/– on the VCR. If the TV screen changes to a different programme each time you press CHAINE +/–, the TV tuning is correct.

To obtain a clear picture from the VCR

If the screen does not appear clearly in step 6 above, go to step 7 to finish this procedure once. Then start again from step 2. After pressing REGL CANAL in step 2, press CHAINE +/– while the RF channel is displayed, so that another RF channel appears. Then tune the TV to the new RF channel so that a clear picture appears.

12

Tuning your TV to the VCR