Panasonic DMR-EX87, DMR-EX77 HDD Hard disk drive handling care, Disk drive handling care

Page 9
DO NOT
This unit
VCR

HDD (Hard disk drive) handling care

The HDD is a high precision recording instrument and because of its long recording capability and high speed operation it is a very special device that is easily susceptible to damage.

As a basic rule, save important content to a disc as backup.

∫The HDD is a device that is not built to withstand vibration/shock or dust

Depending on the setup environment and handling of the HDD some content may become damaged and play and recording may no longer be possible. Especially during operation, do not subject the unit to any vibration, shock, or remove the AC mains lead from the household mains socket. In the event of a power failure during recording or play, the content may be damaged.

∫The HDD is a temporary storage device

The HDD is not an everlasting storage device for recorded content. Use the HDD as a temporary storage place for one-off viewing, editing, or saving recorded content to a disc.

∫Immediately save (backup) all content as soon as you feel there may be a problem with the HDD

If there is an irregularity within the HDD, repetitive strange sounds or problems with picture (block noise, etc.) may result. Using the HDD in this condition may worsen the problem and in the worst case the HDD may no longer be usable. As soon as you notice this type of problem, copy all content to disc and request service. Recorded content (data) on a HDD that has become unusable is unrecoverable.

≥When the HDD has been automatically entered energy save mode (➡ below), or the unit is turned on or off, there may be an unexpected sound. This does not indicate a problem with this unit.

disk drive) handling care

∫Setup precautions

≥Do not place in an enclosed area where the rear cooling fan and the cooling vents on the side are covered up.

≥Place the unit on a surface that is flat and not subject to vibration or impact.

≥Do not place on anything that generates heat like a video cassette recorder, etc.

≥Do not place in an area often subject to temperature changes.

≥Place in an area where condensation does not occur. Condensation is a phenomenon where moisture forms on a cold surface when there is an extreme change in

temperature. Condensation may cause internal damage to the unit.

≥Conditions where condensation may occur

–When there is an extreme change in temperature (moving from a very hot location to a very cold location, or vice versa, or when subjected to an air conditioner or when cooled air directly impacts the unit). When the HDD (warms during operation) is subjected to cold air, condensation may form on the inside of the HDD and may cause damage to the HDD heads, etc.

–When there is high humidity or a lot of steam in the room. –During the rainy season.

In the above situation, without turning the unit on, let the unit adjust to the room temperature and wait 2–3 hours until condensation is gone.

∫Cigarette smoke etc. causes malfunction or

breakdown

The unit may breakdown if cigarette smoke or bug spray/vapor, etc. gets inside the unit.

∫While operating

≥Do not move the unit or subject to vibration or impact. (The HDD may become damaged.)

≥Do not remove the AC mains lead from the household mains socket, or flip the power breaker switch.

While the unit is on, the HDD is rotating at high speed. Sound or movement due to rotation is normal.

∫When moving the unit

1Turn the unit off. (Wait until “BYE” disappears from the display.)

2Remove the AC mains lead from the household mains socket.

3 Move only after the unit has come to a complete stop (approx. 2 minutes) in order to avoid subjecting to vibration and shock. (Even after turning the unit off, the HDD continues operating for a short time.)

Important notes for recording/HDD (Hard

∫HDD recording time remaining

This unit records using a VBR (Variable bit rate) data compression system to vary recorded data segments to match video data segments which may cause differences in the displayed amount of time and space remaining for recording.

If the remaining amount of time is insufficient, delete any unwanted titles to create enough space before you start recording. (Deleting a playlist will not increase the amount of time.)

∫The HDD automatically enters energy save mode

The HDD has been automatically entered energy save mode. (The HDD continues to rotate at high speed while the unit is on. In order to extend the life of the HDD, the HDD will be entered energy save mode if no operation has been performed for 30 minutes while there is no disc on the disc tray.)

≥While in energy save mode play or recording may not start right away because the HDD takes time to be re-activated. ≥When not using the unit, we recommend removing the disc in the tray in order to set the HDD to the energy save mode.

∫Indemnity concerning recorded content

Panasonic does not accept any responsibility for damages directly or indirectly due to any type of problems that result in loss of recording or edited content (data), and does not guarantee any content if recording or editing does not work properly. Likewise, the above also applies in a case where any type of repair is made to the unit (including any other non-HDD related component).

RQT8859

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents RQT8859-L Model No. DMR-EX77Inside of product This Unit is Intended for USE in Moderate ClimatesTable of contents HDD and discs you can use for recording and play HDD, disc and card informationDVD Video Recording format DVD-Video format+R/+RW Video Recording format HDD, disc and card informationRecording modes and approximate recording times Play-only discs 12 cm/8 cm Discs that cannot be playedHDD, disc and card information Suitable SD Cards Cards you can use on this unitStructure of folders displayed by this unit DVD-RAMImportant notes for recording HDD Hard disk drive handling care Disk drive handling careImportant notes for recording/HDD Hard Unit care Disc and card handlingRemote control information Included accessoriesRemote control information Disc and card handling/Unit care/Included accessories/TheControl reference guide Remote controlUnit’s display Main unitControl reference guide Opening the front panelConnecting a television When the unit is not to be used for a long timeMake sure to use the pair of supplied RF coaxial cables Connecting an Analogue television and VCR Connecting a television and VCRConnecting a Digital television and VCR ConnectionConnecting a stereo amplifier Connecting an amplifier with a digital input TerminalOther connections ConnectionConnecting to a receiver Connecting to a TVPreparation Television’sPower off link Power on linkViera Link Hdavi Control TM Easy playbackEasy control only with Viera remote control Press 3, 4 to select your area When clock setting screen is displayedPress OK Press 3, 4 to select the TV aspectPress OK Press 3, 4 to select ProgressivePress 3, 4 to select On and press To enjoy progressive videoWhen the following indicator appears on the unit’s display Set up to match your television and remote controlTest by turning on the television and changing channels Refer to the control reference onSelect the channel Watching analogue and digital broadcastsDigital channel information Press Status to show the information ScreenRecording television programmes Press Drive Select to select the HDD or DVD drivePress ¥ REC to start recording Recording television programmes Disc Insertion/EjectionTo finalise the disc To open the tray without disc finalisationDrive Recording television programmesSelect Direct Navigator MenuPress 3, 4, 2, 1 to select Start and press OK Flexible RecordingPlaying while you are recording Press 1 Play during recordingTo cancel a timer recording on the TV Guide screen Timer recordingPress Guide Press 3, 4, 2, 1 to select the programme Press OKTimer recording Operations in the TV Guide systemPress 3, 4, 2, 1 to select the programme Timer recording Using G-CODEsystem to make timer recordingsREC Mode PROG/CHECK Press G-CodePress PROG/CHECK Manually programming timer recordings≥Date ≥HDD Renew Auto Renewal RecordingPress Drive Select to select the recording drive and press To cancel recording when recording has already begunPress 2, 1 to select Stop Recording and press OK To release the unit from recording standbyCheck, change or delete a programme Relief RecordingAuto Renewal Recording Playing recorded video contents/Playing play-only discs Quick View Operations during playPress Audio Changing audio during playRegarding DivX discs, MP3 discs and still pictures Jpeg Playing DivX discs, MP3 discs and still pictures JpegDivX discs, MP3 discs and still pictures Jpeg Playing recorded videoPlaying DivX discs Press Direct NavigatorSelecting file type to play Press 3, 4 to select the track and press OK Playing MP3 discsPlaying DivX discs, MP3 Press 3, 4, 2, 1 to select a group and press OKPlaying still pictures Press 3, 4, 2, 1 to selectAlbum and press OK Press Drive Select to select the HDD, DVD or SD driveUseful functions during still picture play Slide Show SettingStart Slide Show RotateUsing on-screen menus/Status message Using on-screen menusPress Display Using on-screen menus/Status message Status messagesPress Status Editing titles/chapters Press 3, 4, 2Editing titles/chapters and playing chapters Cancel Protection § Set up Protection §Title operations Partial DeleteCreating playlists Creating, editing and playing playlistsPress 2, 1 to select the source title and press Press ReturnPlaylist operations Editing and playing playlists/chaptersAdd Chapter MoveEditing still pictures Press the Green button to select PicturePress 3, 4 to select the operation and press OK Album and picture operation Cancel Protection § Press 2, 1 to select Yes and press OKPress 2, 1 to select Delete and press OK Add PicturesDeleting titles or pictures during play Delete NavigatorPress Delete ¢ Available disc space after deletingCopying titles or playlists Approximate copying times Max. speedDelete Navigator/Copying titles or playlists Copy Press Function Menu Press 3, 4 to select CopyCopying using the copying list- Advanced Copy Recording and playing while copying To return to the previous screenTo edit the copying list Copy Navigator/Copying list icons and functionsSet Copy Time Setting the unit to copy according to the set timeCopying SD Video from an SD Card VIDEO§ HDD DVD-RAMCopying still pictures Copying using the copying listRegister still pictures for copy To register individual still picturesPress 3, 4 to select To Others Copying all the still pictures on a card- Copy All PicturesPictures and press OK Press 3, 4 to select Copy AllStart play on the other equipment Copying from a video cassette recorderPress ¥ REC DV automatic recording DV Auto RecShow Enter Name screen Entering textPress 3, 4, 2, 1 to select a character and press OK Press SetSetting the protection Common proceduresHDD, disc and card management Providing a name for a discDeleting all titles and playlists-Delete all titles Deleting all the contents of a disc or card-FormatEnabling discs to be played on other equipment-Finalise Selecting the background style-Top MenuCreating Top Menu-Create Top Menu HDD, disc and card managementFunction Menu window To cancel the Child LockChild Lock Press 3, 4 to select an item and press OKSummary of settings Changing the unit’s settingsOPEN/CLOSE Tabs MenusTabs Menus Options Underlined items are the factory presets Changing the unit’s settingsSound Changing the unit’s settingsDTS MpegHdmi Settings§ New Service MessageOn-Screen Messages Grey BackgroundClock Power Save Remote ControlSystem Update Software Update in StandbyPress OK to save the newly found channels TuningRefer to the control reference on Signal Condition DVB Manual TuningPress OK to start scan Press 3, 4, 2 Analogue Manual TuningTo select a Programme positionTo change the setting all at once PAL!#NTSC Press 3, 4 to select Auto-Setup Restart and press OKTV System Press 3, 4 to select the TV system and press OKPress 3, 4 to change the setting Clock SettingsPress OK when you have finished the settings To change the time zoneOn the television MessagesMessages On the unit’s displaySet up Frequently asked questionsWhich aerial is suitable for receiving Region number be played?TV Guide Troubleshooting guide Troubleshooting guide Troubleshooting guide Timer recording does not stop Recording, timer recording and copying Cannot recordEven when is pressed When copying, it takes a longYou want to cancel the ratings PasswordCopying, deleting and setting Play Play fails to start even whenSome channels, No Signal UpdatedTo reset this unit To return all the settings other PresetGlossary RGB Specifications Safety precautions Web Site http//panasonic.net RQT8859-L Index
Top Page Image Contents