Pelco c1943m operation manual Configuring the Comms file for VCRC-P Operation

Page 15

10.Define operator access, save the GPI file, return to the MGR main menu screen and press the tab to bring up the COMMS file (.SCP file). Refer to Figure 13.

11.In the COMMs file assign an equipment number “17” to the port on the CC1 that will be used for communicating to the VCRC-P. Also, set communication settings for 9600 baud and even parity. Save the COMMs file, back out of the MGR program and trans- fer all appropriate configuration files to disk and load these files onto the CC1 to which your VCRC-P configuration is attached. You should now be ready to operate your VCR via direct control from the CM9760-KBD.

Figure 13. Configuring the COMMS file for VCRC-P Operation

Pelco Manual C1943M (9/99)

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents
CM9760-VCRC-P Contents Description Important Safeguards and WarningsFront View PRE-INSTALLATION InformationModels OptionsLEDs DIP SwitchesRear View of CM9760-VCRC-P Rear ViewVCR Input Plugs Input VCR ConnectorsCommunication Connectors Relay Output ConnectorDB-9 Connector Pin-outs Power Input Fuse Replacement Power ConnectionsDIP Switch Settings Setup Preliminary DiscussionDIP Switch Functions Configuring MGR Camera File for VCRC-P Operation Configuring the GPI Setup file for VCRC-P Operation Configuring the Comms file for VCRC-P Operation DAISY-CHAINING InstallationDirect RACK-MOUNT HOOK-UP Remote OperationOperational Overview Functional Block DiagramCM9760-KBD VCR Control Functions Operating the CM9760-VCRC-P from the CM9760-KBDElectrical SpecificationsRegulatory Notices Product Warranty and Return Information
Related manuals
Manual 20 pages 20.41 Kb