Sylvania LC195SL9C owner manual Preparation, 5Basic Connection, Antenna Connection

PREPARATION

Cables not included.

Please purchase the necessary cables at your local store.

5Basic Connection

This section describes how to connect the unit to an antenna, cable receiver or satellite box.

Note:

• Be sure your antenna or other device is connected properly before plugging in the AC power cord.

[Antenna Connection]

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

VHF / UHF antenna

cable TV company

rear of this unit

RF coaxial cable

or

*Once connections are completed, turn on the unit and begin initial setup.

Channel scanning is necessary for the unit to memorize all available channels in your area. (Refer to “Initial Setup” on page 13.)

Note:

•If you have any question about the DTV’s antenna, visit www.antennaweb.org for further information.

•For your safety and to avoid damage to this unit, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than settop versions.

•To switch your reception source easily between antenna and cable, install an antenna selector.

•If you connect to the cable system directly, contact the CATV installer.

[Connection to Cable Receiver or Satellite Box]

Use an HDMI or an RCA component video cable to connect the HDMI or the component video input jack of the unit to the HDMI or the component video output jack of the cable receiver / satellite box.

If you connect to the unit’s component video input jack, connect an RCA audio cable to the audio L/R jack of VIDEO2.

e.g.)

satellite dish

or

cable TV signal including PPV

HDMI OUT

HDMI cable

or

or

rear of this unit

AUDIO OUT

COMPONENT VIDEO OUT

ANT IN

L

R

Y

Pb/Cb

Pr/Cr

RF coaxial

cable

(green)

(blue)

(red)

(green)

(blue)

(red)

RCA component video cable

COMPONENT

VIDEO 2

AUDIO

PCM

VIDEO 1

STEREO

Y

Pb

Pr

L

R

and RCA audio cable

PC-IN

VIDEO

L

AUDIO

HDMI-IN

S-VIDEO

R

cable receiver / satellite box

AUDIO

COAXIAL

AUDIO

L

R

*You can also connect this unit to the cable receiver or satellite box other than the HDMI or the component video output jack because they might have different output jacks.

*Required cables and connecting methods of the cable receiver / satellite box, or the availability channel for the clear QAM may differ depending on the cable/satellite provider. For more information, please contact your cable/satellite provider.

8

EN