Sylvania SSL2606 Safeguards / Precautions, RADIO-TV Interference, Dealer Purchase from

Page 3

15.POWER LINES - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light of power circuits, or where it can fall into such power lines or circuits. When installing an out- side antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

16.OVERLOADING - Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.

17.OBJECT AND LIQUID ENTRY - Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liq- uid of any kind on the TV.

18.SERVICING - Do not attempt to service this TV yourself as opening or removing covers may expose you to dangerous voltage or other haz- ards. Refer all servicing to qualified service personnel.

19.DAMAGE REQUIRING SERVICE - Unplug this TV from the wall outlet and refer servicing to qualified service personnel under the following conditions:

a.When the power supply cord or plug is damaged or frayed.

b.If liquid has been spilled, or objects have fallen into the TV.

c.If the TV has been exposed to rain or water.

d.If the TV does not operate normally by following the operating instruc- tions. Adjust only those controls that are covered by the operating instructions, as improper adjustment of other controls may result in damage and will often require extensive work by a qualified techni- cian to restore the TV to its normal operation.

e.If the TV has been dropped or damaged in any way.

f.When the TV exhibits a distinct change in performance, this indicates a need for service.

20.REPLACEMENT PARTS - When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, injury to persons or other hazards.

21.SAFETY CHECK - Upon completion of any service or repairs to this TV, ask the service technician to perform routine safety checks to determine that the TV is in proper operating condition.

22.HEAT - This TV product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

SAFEGUARDS / PRECAUTIONS

PRECAUTIONS

Place your TV in a room with adequate ventilation.

Keep your TV set away from sources of direct heat, such as heat registers or direct sunlight.

Do not place your TV on soft surfaces, such as rugs or blankets.

Leave enough room for air to circulate around the bottom, top and back of the set.

FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the owner’s manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

Note to CATV system installer:

This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground should be connected to the grounding system of the building as close to the point of cable entry as practical.

The serial number of this product may be found on the back of the TV. No others have the same serial num- ber as yours. You should record the number and other vital information here and retain this book as a perma- nent record of your purchase to aid identification in case of theft.

Model No.

 

Date of Purchase

 

Serial No.

 

Dealer Phone No.

 

Dealer Purchase from

 

Dealer Address

 

IMPORTANT

A NOTE ABOUT RECYCLING:

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regula- tions concerning chemical wastes.

3

EN

Image 3
Contents SSL2606 Important Safeguards Dealer Purchase from PrecautionsSafeguards / Precautions RADIO-TV InterferenceChip Supplied AccessoriesFeatures DTV/TV/CATVContents Functions Remote CONTROL,TOP and Rear Panel Function Installing the Batteries Battery PrecautionsFunctions Preparation for USE Connection Antenna Cable ConnectionConnection to CABLE/SATELLITE BOX Hdmi Connection External ConnectionVideo Connection Component ConnectionAudio Output Connection Analog AUDIO/VIDEO ConnectionAutoscan TV/DTV Initial SettingsInitial Settings Language SelectionChannel Settings Autoscan Initial Settings / Channel SettingsPress Enter To exit the setup, press Setup Channel ListChannell Listi Manual l Register Channel SettingsSelect Register with Enter To exit the setup, press Setup Manual RegisterAntenna Antenna ConfirmationPress Enter To exit the setup, press Setup Language SelectionLanguage Atsc Volume AdjustmentWatching TV Channel Selection NtscSwitching Audio Still ModeWhen using COMPONENT2 input jacks Switching External InputWhen using VIDEO2 or S-VIDEO2 input jack When using COMPONENT1 input jacksWide SidebarFull CinemaScreen Information To clear the display, press Back or Info againBuffy Vampire i Slayer l Refer to Language Selection on Sleep TimerOptional Settings Setup Screen Watching TV / Optional SettingsPicture Adjustment CC2, CC4, Text2 and Text4 Caption Mode CC1 and Text1Closed Caption CC3 and Text3Off Service 1 to ServiceDTV Closed Caption Closed Caption StyleOptional Settings Press Enter Password entry screen is displayed See the following description for setting each itemChip TV-MA Mature audience only TV-14 SelectionNC-17 PG-13Chipip Enter password Confirm password New PasswordSet the method of sound input for Hdmi jack Hdmi AudioMiscellaneous Troubleshooting Guide Miscellaneous Glossary MaintenanceCatv SpecificationsMiscellaneous / Specifications VHF UHFWarranty Statement Regarding NON Authorized Repairs DurationLimits and Exclusions Manual del Usuario Importante Para SU Seguridad Importante Para Nota Sobre Reciclado PrecaucionesSU Seguridad / Precauciones Interferencias EN Radio O TelevisiónCaracterísticas Accesorios SuministradosAccesorios Suministrados / Características / Índice ÍndiceGarantia Limitada Símbolos Empleados EN Este ManualBotones de Número de canal pág.18 FuncionesInstalación DE LAS Pilas FuncionesPrecauciones Relacionadas CON LAS Pilas Preparación Para EL USO Conexión Conexión DE Cable DE AntenaConexión CON Caja DE CONVERTIDOR/CAJA DE Satélite Conexión Hdmi Conexión ExternaEL USO Preparación ParaConexión DE S-VIDEO Conexión DE ComponentePreparación Para EL USO Conexión AUDIO/VIDEO AnalógicaConexión DE Salida DE Audio Autoscan se iniciará automáticamente Preajustes InicialPreajustes Inicial Selección DE IdiomaPresione Enter Ajuste DE LOS Canales PREA. Auto CAAjuste DE LOS Canales Preajustes InicialPara salir del instalación, presione Setup Lista DE CanalesListai Canalesl Manual l Registro ManualAntena Confirmación DE AntenaPresione Enter Para salir del instalación, presione Setup Selección DE IdiomaIdiomaI Uso VOL. X/Y o MUTE. VOL. X/Y Ajuste DEL VolumenPara Mirar TV Selección DE Canal Sobre la emisión de subcanalesCambio DEL Modo DE Audio Modo DE Imagen FijaSi usa el conector COMPONENT1 Selección del modo de entradaSi usa el conector VIDEO1 o S-VIDEO1 Si usa el conector VIDEO2 o S-VIDEO2Ancha Para Mirar TVTotal CineInglés 1/2 Información DE PantallaPresione Info en el mando a distancia Para borrar la pantalla, presione nuevamente Back o InfoEl temporizador se puede ajustar hasta 90 minutos Ajustes Opcionales Pantalla DE InstalaciónPara Mirar TV / Ajustes Opcionales Ajuste del temporizadorAjuste DE LA Imagen 3 y Texto3 SubtítulosModo DE Título 1 y Texto1Servicio 1 a Servicio Subtítulos DE DTVEstilo DE Subtítulo Cerrado Cambie al modo de Subtítulo Cerrado DTVColor Fondo Ajustes OpcionalesAjuste cada elemento Opaco FuenteChipip Introduzca contrasena Clase de MpaaTV-Y Selección Explicación de la categoríaTV-MA TV-PGChipip Introduzca contraseña Confirme contraseña Contraseña NuevaAjuste el método de entrada de sonido para la toma Hdmi Audio HdmiSíntoma Solución Varios Guía DE Localización DE ProblemasVarios Problemas con los SubtítulosMantenimiento GlosarioVarios / Especificaciones EspecificacionesDuracion Limites Y ExclusionesImportante