Connecting to a Digital Audio Device Rear

CONNECTING TO A DIGITAL AUDIO DEVICE (REAR)

You can connect this unit to a digital audio device to enjoy the digital audio of DVD. Connect to an amplifier equipped with digital input jacks, such as MD deck or DAT deck. To play a DVD disc in a Dolby Digital Multi- channel surround format in this unit, connect to a Dolby Digital decoder.

Use an audio coaxial digital cable (commercially available) for the audio connections.

Dolby Digital decoder

ex.

MD deck, DAT deck, etc.

	ANT.
	COAXIAL
	(OUT)	COAXIAL
	To Coaxial digital	or
	To Coaxial digital
(IN)	Audio input jack
	Audio coaxial
	digital cable
	(commercially
	available)
To Coaxial digital
Audio input jack

(IN)

To COAXIAL jack (DVD AUDIO OUT only)

PREPARATION FOR USE

NOTES:

•The audio source on a disc in a Dolby Digital Multi-channel surround format cannot be recorded as digital sound by an MD or DAT deck.

•Be sure to turn off the power to all devices in the system before connecting another device.

•Refer to the Owner's Manuals for the devices to be connected to the unit.

•To connect to a MD or DAT deck, set "DOLBY DIGITAL" to "PCM" for the audio output in the setup mode, and to con- nect to a Dolby Digital decoder, set to "BITSTREAM". (Refer to "AUDIO SETTING" on page 22.) Playing a unit using incorrect settings may generate noise distortion and may also damage the speakers.

INSTALLING THE BATTERIES IN REMOTE CONTROL

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 “AA” penlight batteries into the battery compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the cover.

[BATTERY PRECAUTIONS]

•Be sure to follow the correct polarity as indicat- ed in the battery compartment. Reversed batter- ies may cause damage to the device.

•Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old batteries with fresh ones.

•If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

•Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.