Sylvania DVR90DF owner manual Display menu

Page 12

Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Install two “AA” size batteries (supplied) matching the polarity indicated inside battery compartment of the remote control.

1

2

3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together, although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disas- semble batteries.

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor on the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall off in the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Beeline: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23feet (7m)

30˚

Remote 30˚ control

Guide to Displays on screen menu

This unit uses the following on screen menu for most operations: Easy Setting Menu, Advanced Setting Menu, Title list, Playlist, Original and DISPLAY menu.They allow you to change the playing status of disc during play. The DISPLAY menu also gives you information on the status of the disc.

DISPLAY menu

 

1. Indicates a disc type and a

Hit [DISPLAY] to call up the

format mode.

display menu.This menu will give

NOTE: In some descriptions

you the information on the playing

on this manual, only one disc

disc. Some operations are avail-

type is indicated as an exam-

able while disc is playing.

ple.

 

3

 

1

2. Indicates a channel number.

 

 

3. Indicates a title number, chap-

 

 

 

 

1

1

0:00:00

DVD-Video

ter number and the time

 

 

 

 

lapse of disc play.

 

 

 

CH8

 

 

4

 

2

 

4.Each icon means:

: Search

:Audio

: Subtitle

:Angle (except VR mode)

: Repeat

: Marker

: Noise Reduction

: Zoom

10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Hit Setup Hit Power toBack of this unit DVD+R/+RW discs can be played back only on this unitSelect any blank line and hit Enter After all recordings, finalize your discDate Hit repeatedly to select desired recording timeMenu Others EspañolPrecautions Laser SafetyBefore you start Make your contribution to the environmentPrecautions cont’d Before youInstallation Location Supplied AccessoryDolby Digital Recording Others EspañolTable of contents Features SymbolBefore DescriptionFunctional overview Front PanelFunctional overview cont’d Display menu Setting menus Display message Disc typeRecording speed Title/Track and Chapter markConnections Connection to a TVAfter you have completed connections If your TV is not compatible with Progressive ScanWith this setup Connection to a cable box or satellite boxConnection to an Audio System AudioGetting started Easy DVD recordingEasy DVD recording Cont’d Speed ChannelChannel setting Getting channels auto- maticallyChannel setting cont’d Adding/deleting chan NelsUsing K / L, select Advanced Setting Menu. Hit Enter Using K / L, select TV Audio Select. Hit EnterUsing K / L, select Stereo or SAP. Hit Enter Selecting the TV stereo or SAPSetting the clock Auto Clock SettingUsing K / L, select Clock Hit Enter Using K / L, select Auto Clock Setting. Hit EnterSetting the clock cont’d Manual Clock SettingSetting the daylight sav Selecting the TV aspect ratioIng time Recording Information on DVD recordingInformation Recordable discWhat is CPRM? Information on DVD recording cont’dRestrictions on recording Making discs playable in other DVD player FinalizeFormatting a disc Choosing the recording format of a blank discFormatting a disc cont’d Reformatting a discBasic recording Checking the recording picture and sound qualityOne-touch Timer Recording Turn on the unit and load a recordable discRefer to Recording speed on Timer Recording Timer PROG. . In thisUsing K / L, enter start CH SpeedHit Enter when informa Hit Power to turn off Checking, canceling, or correcting the timer programmingInformation Hit Power Using K / L, select yourTimer Recording cont’d Hints for Timer RecordingPriority of overlapped settings Settings for an external source Connection to an external sourceVideo Before you start Connections Getting startedSettings for an external source cont’d Setting a disc to protectUsing K / L, select Disc Protect OFF ON. Hit Enter Recording from an external sourceFinalizing the discs Finalizing the discs cont’d Auto finalizePlaying discs Information on DVD playBasic playback PlaybackHit Stop C to stop play- back When selecting track Basic playback cont’dPlaying MP3 disc Hit Playb to start play- backPlaying discs using the disc menu Playing discs using the title menuSpecial playback Resume playFast forward / Fast reverse X1.5Special playback cont’d PauseStep by step playback Slow forward / Slow reverse playMarker Setup Using / B, select icon. Hit EnterZoom During playback, hit ZoomUsing Skip H / G Using DisplaySearch Title/Chapter searchSearch cont’d Track searchTime search Repeat/Random/Program playback Repeat playRandom playback Switching subtitles Repeat/Random/Program playback cont’dSelecting the format of audio and video Program playSwitching audio soundtrack Using K / L, select a desired audio channel. Hit EnterSelecting the format of audio and video cont’d Switching camera angles Angle will switch each time youReducing block noise Editing Information on disc editingEditing discs in Video mode Deleting titlesEditing discs in Video mode cont’d Putting names on titlesTitle Name. Hit Enter Setting or clearing chapter markers Chapter Mark. Hit EnterEditing discs in VR mode Original Using K / L, select Original. Hit EnterOriginal list will appear Original menu will appearEditing discs in VR mode Original cont’d Setting titles to protectUsing K / L, select Protect. Hit Enter To protect a whole disc DVD-RW VR mode OnlyReleasing titles from protecting Confirm the indication On OFF. Hit EnterKey icon will disappear from the title in the original list Editing discs in VR mode Playlist Hit Setup button. Using K / L, select Disc. Hit EnterUsing K / L, select Playlist. Hit Enter PlayList will appearEditing discs in VR mode Playlist cont’d Using K / L, select Scene Delete. Hit EnterUsing K / L, select Delete. Hit Enter Deleting parts of titlesUsing K / L, select Edit Title Name. Hit Enter C aUsing K / L, select Chapter Mark. Hit Enter You cannot delete the first chapter of each titleAdd Setting pictures for thumbnails Picture for thumbnail will be setDividing a title Using K / L, select Title Combining. Hit Enter Using s / B, select Yes Hit EnterUsing K / L / s / B, select another title to combine. Hit Combining titlesUsing K / L / / B, select Add New Title. Hit Enter Using K / L / / B, select Delete Playlist. Hit EnterUsing / B, select Yes Hit Enter Adding titles to a PlaylistChanging the Setting menu Tour of the Setting menuLanguage setting Using K / L, select Playback. Hit EnterUsing K / L, select a set Ting. Hit Enter Audio Language Default OriginalLanguage setting cont’d Display settingSubtitle Language Default OFF Using K / L, select Display. Hit EnterAudio setting OSD Language Default English Set the language for OSDScreen Saver Default 10 minutes It will only affect DVD discs during playbackAudio setting cont’d Using K / L, select a setting. Hit EnterDigital Out Settings for Parental lock level Dynamic Range Control Default onFast Forward with Audio Default OFF Record the password in case you forget itSettings for Parental lock level cont’d Password has not been set yetPassword has been set already Change the password Troubleshooting Symptom Remedy PowerOthers Troubleshooting cont’d Symptom RemedyCause Solution OthersError message Cause Solution Language codeGlossary Specifications GeneralEspañol Fácil grabación de DVD¿Qué son títulos y capítulos? Puede editar lo siguiente de la lista de títulosOriginal y Playlist modo VR ¿Qué significa Original o Playlist?Limited Warranty
Top Page Image Contents