Eiki LC-NB4S Computer Input, Selecting Input Source, Selecting Computer System, RGB Analog, Auto

COMPUTER INPUT

SELECTING INPUT SOURCE

DIRECT OPERATION

Choose Computer by pressing INPUT button on Top Control or on Remote Control Unit.

If projector cannot reproduce proper image, select correct input source through MENU OPERATION (see below).

INPUT MENU

INPUT button

Computer

Video

MENU OPERATION

1	Press MENU button and ON-SCREEN MENU will appear. Press		INPUT Menu icon
	POINT LEFT/RIGHT button to move a red frame pointer to		Move a pointer (red arrow)
	INPUT Menu icon.
2			to Computer and press
	Press POINT DOWN button to move a red arrow pointer to		SELECT button.
	Computer and then press SELECT button. Source Select Menu	Computer

will appear.

Source Select Menu

3	Move a pointer to either RGB (Digital) or RGB (Analog) and then
	press SELECT button.

RGB (Digital) When digital signal is connected to DVI terminal, select Digital.

Move a pointer to RGB (Digital) or RGB (Analog) and press SELECT button.

RGB (Analog)

When analog signal is connected to DVI terminal, select Analog.

SELECTING COMPUTER SYSTEM

This projector automatically tunes to most different types of computers based on VGA, SVGA, XGA or SXGA (refer to “COMPATIBLE COMPUTER SPECIFICATIONS” on page 23). When selecting Computer, this projector automatically tunes to incoming signal and projects proper image without any special setting. (Some computers need setting manually.)

Note : Projector may display one of the following messages.

Auto

––––

When projector cannot recognize connected signal as PC PC SYSTEM MENU system provided in this projector, Auto PC Adjustment

function operates to adjust projector and the message “Auto” is displayed on SYSTEM Menu icon. (Refer to

P24.) When image is not provided properly, manual adjustment is required. (Refer to P25 and 26.)

There is no signal input from computer. Make sure the connection of computer and a projector is set correctly. (Refer to TROUBLESHOOTING on page 41.)

SYSTEM Menu icon Displays system being selected.

SELECT COMPUTER SYSTEM MANUALLY

This projector automatically selects PC system among those provided in this projector and PC system can be also selected manually.

1	Press MENU button and ON-SCREEN MENU will appear. Press
	POINT LEFT/RIGHT buttons to move a red frame pointer to PC
	SYSTEM Menu icon.
2	Press POINT DOWN button to move a red arrow pointer to the
	system that you want to set, and then press SELECT button.

PC SYSTEM MENU

SYSTEM Menu icon

Displays system being selected.

The systems on this dialog box can be selected.

Custom Mode (1~5) set in PC

ADJUST Menu. (P25, 26)

22