Eiki LC-NB4S Remote Control Unit, Does not work, Wireless Mouse, Function does not, Work

Page 42

APPENDIX

Problem:

Try these Solution

Remote Control Unit

Check the batteries.

does not work.

Check ALL-OFF switch on Remote Control Unit is set to “ON.”.

Make sure nothing is between Infrared Remote Receiver and Remote Control Unit.

 

 

Make sure you are not too far from a projector when using Remote Control Unit.

 

Maximum operating range is 16.4’ (5m).

 

Make sure the code of Remote Control Unit is set to conform to projector.

 

(See “SETTING” section on page 35, 36.)

 

 

Wireless Mouse

Check cable connection between a projector and your computer.

function does not

Check the mouse setting on your computer.

Turn a projector on before turning on a computer.

work.

 

 

 

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If the problem still persists after following all operating instructions, contact the sales dealer where you purchased the projector or the service center. Give the model number and explain about the problem. We will advise you how to obtain service.

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

42

Image 42
Contents Model LC-NB4S To the Owner Safety Instructions Voor de klanten in NederlandCompliances Federal Communication Commission NoticeTable of Contents Features and Design Compact Design Digital Zoom for ComputerPreparation Name of Each Part of ProjectorHOT AIR Exhausted SETTING-UP Projector Connecting AC Power CordFor Continental Europe Adjustable Feet Preparation Positioning ProjectorRoom Light Preparation Moving Projector Video Input Jack Connecting ProjectorTerminals of Projector Terminal Input JackConnecting to Computer Connecting ProjectorTerminals Projector Connecting to Video Equipment TerminalsOperation of Remote Control Unit Before OperationRemote Control Batteries Installation TOP Controls and Indicators Lamp Replace IndicatorHOW to Operate ON-SCREEN Menu Operating ON-SCREEN MenuFlow of ON-SCREEN Menu Operation Before Operation Menu BAR Guide WindowSound Menu Turning on Projector Basic OperationTurning on / OFF Projector Turning OFF ProjectorKeystone Adjustment Adjusting ScreenZoom Adjustment Picture Freeze FunctionBasic Operation No Show Function Sound AdjustmentTimer Function Direct OperationSelecting Computer System Computer InputSelecting Input Source RGB AnalogResolution Computer Input Compatible Computer SpecificationsResolution FreqPC Adjust Menu PC AdjustmentAuto PC Adjustment Auto PC AdjComputer Input Manual PC Adjustment Display area Display area HFull screen Image Level Select Menu Picture Image AdjustmentsImage Level Select Direct Image 1~4Computer Input Image Level Adjustment Image Adjust MenuPicture Screen Adjustment Screen MenuVideo Input VideoVideo PAL / Secam / Ntsc / NTSC4.43 / PAL-M / PAL-N Component Video Signal FormatSelecting Video System AV System Menu Video or S-VIDEOCinema Tint Video Input Image Level AdjustmentColor SharpnessProvides image at a normal video aspect ratio of 4 Setting Setting MenuSetting Menu To change the code of the Remote Control Unit To change the code of ProjectorLamp Replacement AppendixLamp Replace Lamp Handling Precautions Appendix Lamp Replace CounterOperating Wireless Mouse InstallationOperating Wireless Mouse Cleaning Projection Lens MaintenanceAIR Filter Care and Cleaning RecommendationTroubleshooting Does not work Remote Control UnitWireless Mouse Function does notTechnical Specifications Appendix Configurations of Terminals Monitor OUT Terminal AnalogDVI-I Terminal DIGITAL/ANALOG POA-MCSRL Control Port ConnectorOptional Parts POA-MCMACPage Page Key to better communications Canada