3M MP8030 manual Setup Menu RGB and Video Picture, Select this option, To adjust the following

Some menu options will have an arrow at the end of the line (VIDEO1, VIDEO2). This arrow indicates that a sub-menu (Figure 4-4) with additional options will display if you select that option.

PRESS or ↓↑

SETUP		INPUT		IMAGE OPT.
	RGB1
	RGB2				SYSTEM
	VIDEO1		→			AUTO
	VIDEO2 →					NTSC
	TEST					PAL
	PATTERN					SECAM

NOTE:

VIDEO1 has an arrow to the right. If you select this option the sub-menu SYSTEM will display. The options are: AUTO, NTSC, PAL and

SECAM.

Figure 4-4. Selecting VIDEO1

Press the up/down menu arrow (↑ MENU ↓) or move the remote control stick switch (up/down) to highlight the desired sub-menu option.

To exit a menu and return to the video/RGB image, press	or	MENU
		. You have 10 seconds to make a

menu selection and then the projector will automatically return to the video or RGB image.

4-6. Setup Menu (RGB and Video Picture)

Press the left/right menu arrow (← MENU → ) or move the stick switch left/right to select the SETUP menu. Depending on the current input source either the RGB menu or Video menu will display.

	RGB Signal Input
SETUP	INPUT	IMAGE	OPT.
VOLUME
BRIGHT
CONTRAST
V POSIT		99
H POSIT		101
H PHASE		14
H SIZE		800

VIDEO Signal Input

SETUP INPUT IMAGE OPT.

VOLUME

BRIGHT

CONTRAST

SHARPNESS

COLOR

TINT

Select this option:

VOLUME

BRIGHT

CONTRAST

SHARPNESS (video only)

COLOR (video only)

TINT (video, except PAL video)

V.POSIT (RGB only)

H.POSIT (RGB only)

H.PHASE (RGB only)

H.SIZE (RGB only)

To adjust the following:

Set speaker/Audio-Out volume (low to high)

Set picture brightness (dark to bright)

Set picture contrast (low to high)

Set sharpness of video signal (soft to sharp)

Set amount of picture color (less to more)

Set video picture tint (red to green)

Move the picture image up or down

Move the picture image left or right

Decrease the picture flicker

Set size of horizontal picture (narrow or widen)

 3M 1996 3M  Multimedia Projector MP8030 13