3M MP8030 manual Now What?, Adjusting the Projector Elevation, Ceiling Mount Considerations

Adjusting the Projector Elevation

The elevation of the projected image can be adjusted by pushing the lock lever (Figure 3-11) on each projector leg to the unlock position. Raise or lower the projector body to extend or retract the projector leg until the desired elevation (1 to 7°) is obtained. Push the lock lever to the lock position to secure each projector leg.

UNLOCK LOCK

Lock

Lever

Foot

Figure 3-11. Projector Leg Adjustment

Note

Both projector legs must be raised or lowered the same amount to project a level image on the screen. Minor elevation adjustments can be made by turning the foot in a clockwise or counterclockwise direction.

Ceiling Mount Considerations

An optional ceiling mount bracket (Figure 3-12) is required to install the MP8030 from the ceiling. For this type of installation, the image must be inverted. Refer to Section NO TAG, Inverting the Image for more details.

90°

Figure 3-12. Optional Ceiling Bracket

Viewing from

backside of

semi-transparent90°

screen

Figure 3-13. Rear Projection Viewing

Rear Projection

A semi-transparent screen (Figure 3-13) can be used to project an image and view it from the backside of the viewing screen. For this type of installation, the image must be inverted. Refer to section NO TAG Inverting the Image for more details.

3-3. Now What?

Your MP8030 is now connected and ready to power on. Turn to Section 4 for details on operating the projector.

 3M 1996 3M  Multimedia Projector MP8030 9