Section 6: Lamp Replacement
6-1. Metal Halide Projector Lamp
If the projected image appears dark or the LAMP indicator light comes on, the lamp may be getting old and in
TIMER
need of replacement. Press and hold the TIMER 
button for two seconds to display the number of
operating hours for the current projector lamp. Under normal operating conditions, the lamp should last approximately 2000 hours. After that time, the lamp will slowly grow dimmer.
For best results, replace the lamp after 2000 hours of usage.
Note
The LAMP indicator will come on if the lamp becomes too hot. If this happens, wait for the fan motor to stop running, turn the power off and let the projector cool. Check for airflow blockage, clean the air filter then turn the power on. If the LAMP indicator comes on again, call customer service or your dealer.
6-2. Replacing the Lamp
To replace the lamp, the following is needed:
DPhillips screwdriver
DStandard #2 screwdriver
DMetal halide lamp
Important
Always use lamp type: 260W Metal Halide, 70 VDC, 4.3A, Part Number
Power OFF: Press the Standby/ON 
button on the projector control panel or remote control and wait for the fan motor to cycle off. Then, turn off the power switch and unplug the power cord.
!
There are high voltage parts inside the cabinet that may cause an electric shock. Always unplug projector when changing the lamp.
!
Lamp and adjacent metal parts become extremely hot and can cause severe burns to your fingers. Allow the projector to cool for at least 1 hour before replacing the lamp.
Remove Lamp Access Door: The lamp access door is located on the back of the machine on the right side (Figure
Note
The screw is a
Lamp
Access
Door
Lamp
Module
Screw
Figure 6-1. Lamp Access Door
20 | | Multimedia Projector MP8030 | 3M 1996 |
3M |
|