3M MP8030 manual Reset the Operating Hours Press and hold down

Retaining Screws: Use a standard screwdriver to unscrew the lamp module retaining screws (Figure 6-2).

Note

There are four lamp module screws that must be loosened. These screws are self-containing screws that cannot be removed from the lamp module.

Screws

Screws

Lamp

Module

Figure 6-2. Lamp Module Retaining Screws

Remove Lamp Module: Grasp the lamp module with one hand and the projector body opening with the other hand (Figure 6-3). Apply upward pressure to the projector body as you slide the lamp out.

Figure 6-3. Slide Lamp Out to Remove

Insert Lamp Module: Carefully insert the new lamp module into the opening and slide it all the way back into place (Figure 6-5). Check the lamp module to be sure that it is fully inserted and flush against the back wall.

Tighten the lamp module retaining screws to secure the lamp module in place (Figure 6-2).

Insert the hinge tabs on the left side of the lamp access door, then close and tighten the retaining screw to secure the door (Figure 6-1).

Figure 6-5. Slide Lamp In to Insert

Reset the Operating Hours: Press and hold down

	TIMER
the TIMER		button for two seconds to display
the lamp
	operating hours. Press the RESET
	→ 0		Cancel

button to display the reset sub-menu (Figure 6-4).

Move the stick switch left/right to select either Figure 6-4. Reset Hours

the 0 field to reset the hours or the Cancel field to exit the menu and not change the counter.

For best results, lamps should be replaced after 2000 hours.

 3M 1996 3M  Multimedia Projector MP8030 21