Wachsmuth & Krogmann TQ 1.0 manual Setting Cutter Speed

Q-PON CUTTER

SECTION V SETUP & OPERATING PROCEDURES (CONT.)

1.Install FHCS through base plate and stand support into bottom of TQ 1.0 (Figure 1)

5.Always change the cutter brush when changing blades.

Setting Cutter Speed

1.The low speed side of the gearbox engaged (3a), the dial speed control should always be set on “A”(3b). This will keep the blade at its optimum speed of 100 rpm (Figure 3).

Figure 1

2.Attach vacuum source to port on back of TQ 1.0 if desired.

Saw Blade Installation

1. Slide back the cutting saw blade guard.

Figure 3

2.Remove cutter tensioning bolt and retaining washer from spindle.

3.Position saw blade for contact rotation over spindle.

4.Replace retaining washer and tensioning bolt using supplied hand tools (Figure 2).

Weld Sample Cutting

1.Cut off desired length from weld centerline.

2.Set cutter depth control to desired diameter (Figure 4).

Figure 2

Figure 4

15