Initial installation
Explanations of the setting possibilities, including the upgradeable satellite reception:
Location of | Select the country for | |
TV set | If UK or IRL is selected for the location of TV set, it is pos- | |
| ||
| sible to activate | |
| A dialogue appears, where you can confirm to set the | |
| operating software to the selected location. | |
| If Yes is selected and confirmed with OK, the TV set turns | |
| off and on again automatically. First installation starts | |
| again after activating the operation software. | |
| If | |
| used anymore. Only terrestrial/cable and | |
| are available. |
|
Antenna | Antenna/cable (analogue): analogue stations via | |
selection | cable/antenna | |
| digital, terrestrial stations | |
|
| digital stations via cable |
|
| digital stations via satellite |
| digital stations via satellite | |
Encrypted | You can state whether coded stations are to be searched | |
stations | for in the search/update. Select yes then coded stations | |
| are also searched for. However, these stations can only | |
| be received in connection with a CA module and the | |
| appropriate Smart Card. Handling of the CA module is | |
| described on page 34. |
|
If you are using an active antenna, then select yes (5V) | ||
Antenna | for the antenna power supply. | |
The conventional settings will be derived from the selec- | ||
Settings | tion of set location. Only change this if you know other | |
| symbol rates and modulation types or if you have to spec- | |
| ify the network ID for your cable network (information | |
| available from your cable network provider). If you want | |
| to run the station search independently of the channel | |
| grid, select frequency search for the search method. | |
| Select which satellite(s) you receive from a list. For more | |
Satellite | than one satellite, select the type of your changeover | |
system | switch or communal satellite system additionally. Ask | |
| your dealer in this regard. |
|
High band | Specify here whether the high band of the selected satel- | |
| lite is to be searched in addition to the low band. |
LNC Normally, you do not need to change the values for high frequencies and low band, unless the LNC (LNB) of your satellite Low Band / system uses a different oscillator frequency (important High Band for the frequency display).
After you have made these settings, you should receive the picture and sound of the selected satellites (only with Astra1 and HOTBIRD).
Search If you want to run the station search independently of method the channel grid, select frequency search for the search
method.
Symbol rates The symbol rates are specified by the satellite provider
and do not normally need to be changed.
Favoured Select the signal source from a list, the station of which is signal source to be at the top of your station list (starting with station
slot 1).
Start search Start the automatic station search with OK.
First Tv stations, then radio stations are searched for.
The stations found in the automatic search are divided into the appropriate station blocks depending on the previously selected antenna cables (signal sources). Subsequently the stations can only be
Any mixed sorting of stations from different signal sources is only possible with the favourites list.
➠For TV sets with
Connecting Then the connection and sound component wizard additional starts which helps you to log in, set and connect video devices recorders, decoders, a loudspeaker system or a HiFi/AV amplifier to your TV set. DVD players and DVD recorders
are already registered at the factory.
You can start the connection wizard and the sound components wizard manually later and add new devices. Further information is available from page 37 (Connection wizard) and page 41 (Sound components wizard).
continued on next page
13 -