Metz 42TM92 operating instructions Search, Reset

3. The remote control

K e y	D V D		H i F i
		C D ( I-II )	T U N E R ( ￿ )		T A P E (	)
On	On / Standby	ON: Display time/track	ON:Radio-text on/off
		ON&AV, ON:On/Standby ON&AV, ON: On/Standby
	Return
	Angle		I-II & ON: CD		I-II & ON: CD
0...9	Numeric keys: title selection	Num.keys: title select.	Num.keys: progr.select.
	Cursor up/down	Title +/–	Programme +/–
	Cursor left/right		Frequency +/–
OK	OK / Enter
Vol.+/–	TV volume +/-	AMP volume +/-	AMP volume +/-		AMP volume +/-
Mute	TV mute
Menu	MENU
P-	Title
Text	Display
Info
P+	Pause	Pause
red	STOP/Search	STOP/OPEN-CLOSE/Search	Num.key	=Search	Search
green	PLAY	PLAY
white	EJECT
yellow	Skip +
blue	Skip –
￿	Audio	￿ & ON: Tuner			￿ & ON: Tuner

	I-II	Subtitle	& ON: Tape input	& ON: Tape input
21	TV
22	AV	Repeat	AUX input	AUX input	AUX input
23	Select	Select operating level	Select operating level	Select operating level	Select operating level

Search:

Proceed as described above for entering the codes for VCR, DVD, CD, tuner, tape as far as the step where the code number is entered. Then enter "001" for the search function. The LED blinks 2x to acknowledge the input. Then press and hold the search key (which depends on the operating level; see the table) until the device stops or switches off (a STOP or OFF command is automatically trans- mitted every 1.5 seconds).

Then release the search key and press the Select key to save the code which was found.

Reset:

Proceed as described above for entering the codes for VCR, DVD, CD, tuner, tape as far as the step where the code number is entered. Then enter "000" for the reset function. The LED blinks 2x to acknowledge the input. All codes are now reset to the factory default settings.

The reset is executed for all operating levels, regardless of the level from which it is initiated.

67