Panasonic NV-MV15 Series, Hi-Fi) Timer recording, Automatic SP/LP selection, VPS/PDC function

Page 11

Timer recording

SV120 HV60 HV50 MV15

Automatic SP/LP selection

A:If, at the beginning of a timer programme, there is not enough tape remain to complete it, the SP/LP function will automatically run the tape at LP speed. This ensures that the entire programme will be recorded. If the LP mode is not enough to 'stretch' the remaining tape to fit you will not be able to record all of the TV programmes.

It is not possible to automatically activate the EP mode.

	SV120 HV60 HV50 MV15
	VPS/PDC function
VPS/PDC	This setting defines how a special signal controls the beginning and end of
	a recording session. If a TV programme begins or ends earlier or later than
	planned, this function synchronises the beginning and end of the recording
	session with the actual beginning and end of the TV programme.
	ON : The station transmits VPS/PDC signals. You must set the timer to the
	time specified in the TV magazines. Use the special VPS time the TV
	magazine may indicate.
	- - - :The station does not transmit VPS/PDC signals. Try to set the start and
	stop time such that the entire film can be recorded even if a programme
	begins or ends earlier or later than planned.

11

Image 11

Contents Operating Instructions Video Cassette RecorderContents PrecautionsPage Playback Remote control functionsControl menu Playback functionsAudio Timer3D DNR FrontCVC Super ConnectorsNV-SV120 Settings Enter Auto SetupTape remain counter RecordingVPS/PDC function Timer recordingAutomatic SP/LP selection PROG/CHECK Enter Timer recordingPlaying back programmed recordings Quitting the timer modeChecking the timer programme Changing or cancelling a timer programmeShowView Timer recordingEditing a programme Intelligent TimerFinding the start of a recording Audio settingsGeneral functions Repeat playbackErasing a cassette OFF Timer Limiting the recording and playback time3D DNR, 3-Dimensional Digital Noise Reduction Menu Overview Setting a new Channel Manual SetupMenu Changing the name of TV stationsChanging the order of TV stations or deleting a station Creating a new station table Shipping condition / restoring factory defaultsOSD Menu OthersAV2 AV1 OUTDimmed VHS RECVHS ET REC EXT LinkDecoder Connecting a decoderSetting the channel to Decoder SV120 HV60 External recording controlPlaying back Ntsc video cassettes Amplifier Nicam sound systemNtsc playback Connect an amplifierCassette erasure protection Inserting batteries into the remote control unitBefore requesting service Recording functions do not Remote control unit doesBad picture or sound Not work properlySV120 HV60 HV50 MV15 Power consumption SpecificationsThese specifications are subject to change without notice RFC Index